ExamGecko
Login
Home / Huawei / H12-811_V1.0 / List of questions
Ask Question

Huawei H12-811_V1.0 Practice Test - Questions Answers, Page 17

Add to Whishlist

List of questions

Question 161

Report Export Collapse

Regarding the corresponding relationship between the access control list number and type, the following description is correct ()

The basic access control list number range is 1000-2999
The basic access control list number range is 1000-2999
The number range of the second-level access control list is 4000-4999
The number range of the second-level access control list is 4000-4999
The number range of the interface-based access control list is1000-2000
The number range of the interface-based access control list is1000-2000
Advanced access control list number range is 3000-4000
Advanced access control list number range is 3000-4000
Suggested answer: B
asked 18/09/2024
Jonaid Alam
46 questions

Question 162

Report Export Collapse

What is the number range of the Layer 2 ACL? ()

2000-2999
2000-2999
3000-3999
3000-3999
4000~4999
4000~4999
6000~6031
6000~6031
Suggested answer: C
asked 18/09/2024
KOSSIBA LANTONKPODE
38 questions

Question 163

Report Export Collapse

Two authentication domains "Area1" are configured on a router acting as an authentication server

And "AreA. 2", If the user uses the correct username'huawei' and password"hello" for authentication.

Then which authentication domain will this user be assigned to? ()

Authentication domain "AreA 1"
Authentication domain "AreA 1"
Authentication domain "default domain\
Authentication domain "default domain\
Suggested answer: B
asked 18/09/2024
Przemysław Doczkal
51 questions

Question 164

Report Export Collapse

What is the destination IP address of the DHCP DISCOER message? ()

127.0.0.1
127.0.0.1
224.0.0.1
224.0.0.1
224.0.0.2
224.0.0.2
255.255.255.255
255.255.255.255
Suggested answer: D
asked 18/09/2024
J.J. van Ingen
44 questions

Question 165

Report Export Collapse

Which of the following IEEE802.11 standards does not support the 5GHz frequency band for communication? ()

802.11g
802.11g
802.11aC. wave 2
802.11aC. wave 2
802.11aC. wave 1
802.11aC. wave 1
802.11n
802.11n
Suggested answer: A
asked 18/09/2024
Ruben Campoy
47 questions

Question 166

Report Export Collapse

In the history of WLAN development, which of the following is not included in the main wireless protocol standards in the primary mobile office era? ()

802.11g
802.11g
802.11a
802.11a
802.11b
802.11b
802.11ac
802.11ac
Suggested answer: D
asked 18/09/2024
Peter Sundstrom
38 questions

Question 167

Report Export Collapse

The protocol uses the P/

mechanism to speed up the upstream port's transition to the Forwarding state, but what is the reason for no temporary loop? ()
mechanism to speed up the upstream port's transition to the Forwarding state, but what is the reason for no temporary loop? ()
Ensure that there will be no temporary loops through the synchronization mechanism
Ensure that there will be no temporary loops through the synchronization mechanism
Speed up port role election
Speed up port role election
Reduced the time of ForwarD. Delay
Reduced the time of ForwarD. Delay
Edge port
Edge port
Suggested answer: A
asked 18/09/2024
Joseph Bauer
45 questions

Question 168

Report Export Collapse

The router running the 0SPF protocol can reach the FULL state after completing the LSDB. synchronization. ()

True
True
False
False
Suggested answer: A
asked 18/09/2024
Peter Klaffehn
45 questions

Question 169

Report Export Collapse

Protocol Priority Switch A. and Switch B. adopt LACP mode link aggregation, and all interfaces join the link aggregation group.

At the same time, set the maximum number of active ports to 3. Then which port of switch A is not an active port? ()


G0/0/2
G0/0/2
G0/0/1
G0/0/1
G0/0/3
G0/0/3
G0/0/0
G0/0/0
Suggested answer: C
asked 18/09/2024
Michaelj Lauth
42 questions

Question 170

Report Export Collapse

Which information of the data frame is used by the interface to determine whether to forward Layer 2 or Layer 3 forwarding? ()

Source IP
Source IP
Source MAC
Source MAC
Destination port
Destination port
Destination MAC
Destination MAC
Suggested answer: D
asked 18/09/2024
Tanvir Anjum
46 questions
Total 984 questions
Go to page: of 99
Open VPLUS File
Convert VPLUS to PDF

Related questions

In the network shown in the figure below, the router receives a data packet with a destination IP address of 11.0.12.1 from host A. This data packet is forwarded by the router. What are the destination mc and destination IP? () (Single-choice question)
The MAC address table of existing switches is shown in the figure. Which of the following statements are correct? () (Single-choice question) <Huawei>display mac address MAC address table of slot 0: MAC Address VLAN/PEVLAN CEVLAN Port Type LSP/LSR-ID VSI/SI MAC-Tunnel 5489 9811 0b49 1 Eth0/0/3 static 0/ Total matching items on slot 0 displayed =1 MAC address table of slot 0: MAC Address VLAN/ PEVLAN CEVLAN Port Type LSP/LSR-ID VSI/SI MAC-Tunnel 5489-989d-1d30 1 Eth0/0/1 dynamic 0/- 5489-9885-18a8 1 Eth0/0/2 dynamic 0/- Total matching items on slot 0 displayed =2
The MAC address table of existing switches is shown in the figure. Which of the following statements are correct? () (Single-choice question)
Which of the following statements is true about the edge port in RSTP?
Does the WEP security policy support the use of TKIP for data encryption?
The network structure and OSPF partition are shown in the figure. Except for RTA in the figure, the routers RTB, RTC and RTD are all ABR routers. ()(True or False)
Which of the following statements are true about the dynamic MAC address table?
The two switches shown in the figure below have both enabled the STP protocol. Which port will eventually be in the Blocking state? ()
The administrator made the configuration on the router as shown in the figure. At the same time, the administrator wants to assign a shorter lease period to the DHCP address. Which of the following commands should be used? () (Single-choice question) ip pool pooll netyork10.10.10.0ask255.255.255.0 gateway-list 10.10.10.1
If host A has the ARP cache of host B. , host A. can ping host B. ()