ExamGecko
Home / Huawei / H12-811_V1.0 / List of questions
Ask Question

Huawei H12-811_V1.0 Practice Test - Questions Answers, Page 30

List of questions

Question 291

Report Export Collapse

When the IPv4 protocol is used as the network layer protocol, which field is not included in the network layer header? ()

Source IPv4 Address
Source IPv4 Address
TTL
TTL
Destination IPv4 Address
Destination IPv4 Address
Sequence Number
Sequence Number
Suggested answer: D
asked 18/09/2024
Sonjoy Kanwal
47 questions

Question 292

Report Export Collapse

Take effect immediately after the Router ID of the OSPF process is modified ()

True
True
False
False
Suggested answer: B
asked 18/09/2024
Tunde Ogunkoya
33 questions

Question 293

Report Export Collapse

How many types of OSPF packets are there? ()

2
2
4
4
5
5
3
3
Suggested answer: C
asked 18/09/2024
AHOPlvaro Zorrilla
42 questions

Question 294

Report Export Collapse

Network switch A and router A are connected by two links. The two links are aggregated in manual load sharing mode. The aggregated port number is 1, and the aggregated link needs to carry VLAN TAG100 when forwarding dat a. The switch When A uses a trunk link, which of the following configurations need to be used by switch A? ()

2
2
4
4
5
5
3
3
Suggested answer: B
asked 18/09/2024
Ian Lloyd
42 questions

Question 295

Report Export Collapse

By default, the port cost calculated by STP has a certain relationship with the port bandwidth, that is, the larger the bandwidth, the higher the cost ()

Big
Big
Unanimous
Unanimous
uncertain
uncertain
small
small
Suggested answer: D
asked 18/09/2024
Wasawatt Ch
42 questions

Question 296

Report Export Collapse

In the RSTP standard, in order to improve the convergence speed, the port that the switch is directly connected to the terminal can be defined as ()

Edge port
Edge port
Root port
Root port
Fast port
Fast port
Backup port
Backup port
Suggested answer: A
asked 18/09/2024
Jeffrey VanBemmel
41 questions

Question 297

Report Export Collapse

The Backup port in RSTP can replace the failed root port ()

True
True
False
False
Suggested answer: B
asked 18/09/2024
ILLIA VELIASEVICH
51 questions

Question 298

Report Export Collapse

All four switches run STP, and various parameters adopt default values. If the G0/0/2 port of switch C is blocked and the configuration BPDU cannot be sent through this port, how long will the blocked port in the network enter the forwarding state ()

About 3 seconds
About 3 seconds
About 50 seconds
About 50 seconds
About 30 seconds
About 30 seconds
About 15 seconds
About 15 seconds
Suggested answer: B
asked 18/09/2024
Shivanth Jha
39 questions

Question 299

Report Export Collapse

The link aggregation interface can only be used as a Layer 2 interface ()

True
True
False
False
Suggested answer: B
asked 18/09/2024
Rakesh Sharma
41 questions

Question 300

Report Export Collapse

If the largest number in an ACL rule is 12, by default, the user does not specify a number when configuring a new rule, then the number assigned to the new rule by the system is? ()

13
13
15
15
14
14
16
16
Suggested answer: B
asked 18/09/2024
Lucas Bila
38 questions
Total 984 questions
Go to page: of 99

Related questions