ExamGecko
Home / Huawei / H12-811_V1.0 / List of questions
Ask Question

Huawei H12-811_V1.0 Practice Test - Questions Answers, Page 48

Add to Whishlist

List of questions

Question 471

Report Export Collapse

Switch stacking supports more than two devices, and multiple switches can be grouped into a logical device through stacking. ()

Become a Premium Member for full access
  Unlock Premium Member

Question 472

Report Export Collapse

At which layer of the OSI reference model do Ethernet switches operate? ( )

Become a Premium Member for full access
  Unlock Premium Member

Question 473

Report Export Collapse

The bridge ID of the STP protocol in the switching network is as follows. Which of the following bridge IDs will be the root bridge? ()

Become a Premium Member for full access
  Unlock Premium Member

Question 474

Report Export Collapse

RTA Uses NAT technology and realizes many-to-many NAPT address translation by defining an address pool, so that hosts in the private network can access the public network. Assuming that there are only two public network P addresses in the address pool, and they have been assigned to hosts A and

B for address conversion, and at this time, if the host also wants to access the public network, the following description is correct ().


Become a Premium Member for full access
  Unlock Premium Member

Question 475

Report Export Collapse

The following two configuration commands can implement router RIA. The route to the same destination 10.1.1.1.0 is active and standby:

[RTA] ip route-static 10.1.1.0/24 12.1.1.1 permanent

[RTA] ip route-static 10.1.1.0/24 13.1.1.1

Become a Premium Member for full access
  Unlock Premium Member

Question 476

Report Export Collapse

The administrator wants to configure the P address on the G0/0/0 interface of the router. Which of the following addresses is correct?

Become a Premium Member for full access
  Unlock Premium Member

Question 477

Report Export Collapse

To ensure that the same data stream is forwarded on the same physical link, which load sharing method does Eth Trunk use?

Become a Premium Member for full access
  Unlock Premium Member

Question 478

Report Export Collapse

Which bridge is in the configuration BPDU sent by the switchID. Impossible to appear?

Become a Premium Member for full access
  Unlock Premium Member

Question 479

Report Export Collapse

By default, the bridge priority of Huawei switches is 32768.

Become a Premium Member for full access
  Unlock Premium Member

Question 480

Report Export Collapse

The Trunk port can send both tagged data frames and untagged data frames.

Become a Premium Member for full access
  Unlock Premium Member
Total 984 questions
Go to page: of 99

Related questions