ExamGecko
Home / Huawei / H12-811_V1.0 / List of questions
Ask Question

Huawei H12-811_V1.0 Practice Test - Questions Answers, Page 63

Add to Whishlist

List of questions

Question 621

Report Export Collapse

The output information of the sub-interface of a certain router's aggregation port 1 is shown in the figure. Based on this information, which of the following statements is correct? ( )

[Router A] display Interface Eth-Trunk 1.100Eth-Trunk1.100 current state UP Line protocol current state UP Last line protocol up time 2019-03-04 10:22:40 UTC. -08:00 Description: HUAWEI, ARSeries, Eth-Trunk1.100 Interface Route Port, Hash arithmetiC. :According to SIP-XOR-DIP, Maximal BW:2G. Current BW:2G, The Maximum Transmit Unit is 1500 Internet Address is 10.0.12.2/24 IP Sending Frames'Format is PKTFIT ETENT 2, Hardwareaddress 1s 00e0-fc3b-2015 Current system time:2019-03-04 10:24:29-08:00 Last 300 seconds input rate0 bits/sec.0 packets/sec Last 300 seconds output rate 0 bits /seC. 0 packets/sec Realtime 0 seconds inputrate 0 bits/seC. 0 packets/sec Realtime 0 seconds output rate 0 bits/seC. 0 packets/sec Input: 6 packets, 574 bytes,

Output: 7 packets, 638 bytes, Input bandwidth utilization 0% Output bandwidth utilization 0%

PortName Status Weight

GigabitEthernet0/0/1 UP 1 GigabitEthernet0/0/2 UP 1

The Number of Ports in Trunk:2 The Number of UP Ports in Trunk:2*

Become a Premium Member for full access
  Unlock Premium Member

Question 622

Report Export Collapse

On Huawei ARG3 series routers, what authentication modes does AAA support? ()

Become a Premium Member for full access
  Unlock Premium Member

Question 623

Report Export Collapse

The output information of a certain device is shown in the figure. Which of the following statements is correct? ( )

display interface G1gabitEthernet 0/0/0 G1 gabi tEthernet0/0/0 currentstate UP Line protocol current state UP Route Port,The Maximum Transmit Unit is 1000 Internet Address is 10.0.12.2/24 IP Sending Frames'Format is PRTFMT ETENT 2.Hardware address is 00e0-fc22-4fff Port Mode:FORCE COPPER SpeeD. :100, Loopback:NONE Duplex:FULL, Negotiation:DISABLE Md1 AUTO Last 300 seconds input rate 24 bits/seC. 0 packets/sec Last 300 seconds output rate 24 bits /seC. 0 packets/seC. *

Become a Premium Member for full access
  Unlock Premium Member

Question 624

Report Export Collapse

Which of the following commands can be used to query the configuration information of the device's 0SPF protocol? ()*

Become a Premium Member for full access
  Unlock Premium Member

Question 625

Report Export Collapse

Which of the following statements about IPv6 anycast addresses are correct? ()*

Become a Premium Member for full access
  Unlock Premium Member

Question 626

Report Export Collapse

Which of the following options describes the concept of the IEV architecture correct? ()*

Become a Premium Member for full access
  Unlock Premium Member

Question 627

Report Export Collapse

Regarding the control plane of the device, which of the following statements is correct? ()*

Become a Premium Member for full access
  Unlock Premium Member

Question 628

Report Export Collapse

Which of the following networks belong to a local area network? ()

Become a Premium Member for full access
  Unlock Premium Member

Question 629

Report Export Collapse

Which of the following features does the OSPF protocol have? ()*

Become a Premium Member for full access
  Unlock Premium Member

Question 630

Report Export Collapse

Which of the following elements are included in the routing table? ()*

Become a Premium Member for full access
  Unlock Premium Member
Total 984 questions
Go to page: of 99

Related questions