Huawei H12-811_V1.0 Practice Test - Questions Answers, Page 95
List of questions
Question 941

After a switch restarts, static MAC address entries saved on the switch remain in the MAC address table.
Question 942

Which of the following is correct regarding the configuration of the trunk port and access port on a switch?
Question 943

After an Eth-Trunk in LACP mode is created, devices on both ends send LACPDUs to elect the Actor. Which of the following parameters in LACPDUs determine the Actor election?
Question 944

RSTP uses the proposal/agreement mechanism to shorten the time that an upstream port waits before transitioning to the Forwarding state, but no temporary loop occurs. Why?
Question 945

Assuming all STP enabled switches have the same bridge priority. The MAC address of switch A is 00-e0-fc-00-00-40, the MAC address of switch B is 00-e0-fc-00-00-10, the MAC address of switch C is 00-e0-fc-00-00-20, and the MAC address of switch D is 00-e0-fc-00-00-80. Which switch will be elected as the root switch?
Question 946

Which of the following port states are included in Rapid Spanning Tree Protocol (RSTP)?
Question 947

According to the one-armed routing configurations shown in the figure, even if ARP proxy is disabled on the sub-interface of R1, the Administration Dept and Finance Dept can still communicate with each other.
Question 948

If a device running STP receives an RSTP configuration BPDU, it discards the BPDU.
Question 949

A Layer 2 switch works at the data link layer. As such, it can identify MAC addresses in data frames, forward data based on MAC addresses, and record mappings between MAC addresses and interface numbers in its MAC address table.
Question 950

Which of the following statements is true about link aggregation in manual load balancing mode?
Question