ExamGecko
Login
Home / Juniper / JN0-363 / List of questions
Ask Question

Juniper JN0-363 Practice Test - Questions Answers, Page 7

Add to Whishlist

List of questions

Question 61

Report Export Collapse

How does a Junos device learn about MAC addresses when II is first connected to an Ethernet LAN?

Become a Premium Member for full access
  Unlock Premium Member

Question 62

Report Export Collapse

When would you use the qualified-next-hop statement with a static route?

Become a Premium Member for full access
  Unlock Premium Member

Question 63

Report Export Collapse

Click the Exhibit button.

Juniper JN0-363 image Question 63 50724 09182024211219000000

Referring to the exhibit, you have an established RSVP LSP between R1 and R4 when you experience a link failure between R2 and R3.

Which two statements are correct? (Choose two.)

Become a Premium Member for full access
  Unlock Premium Member

Question 64

Report Export Collapse

Click the Exhibit button.

Juniper JN0-363 image Question 64 50725 09182024211219000000

All devices in the network are configured correctly and the path requirements are valid.

Referring to the exhibit, which two statements are correct? (Choose two.)

Become a Premium Member for full access
  Unlock Premium Member

Question 65

Report Export Collapse

By default, which two statements are correct about switch ports on a Junos device? (Choose two.)

Become a Premium Member for full access
  Unlock Premium Member

Question 66

Report Export Collapse

Which BGP message type is used to re-advertise routes that have already been sent to a peer and acknowledged using TCP?

Become a Premium Member for full access
  Unlock Premium Member

Question 67

Report Export Collapse

Which new field is added to an IPv6 header as compared to IPv4?

Become a Premium Member for full access
  Unlock Premium Member

Question 68

Report Export Collapse

You are troubleshooting two OSPF routers that have an adjacency that remains in the ExStart state.

What would cause this problem?

Become a Premium Member for full access
  Unlock Premium Member

Question 69

Report Export Collapse

Which two statements ate correct about the BGP next-hop attribute value? (Choose two.)

Become a Premium Member for full access
  Unlock Premium Member

Question 70

Report Export Collapse

Exhibit

Juniper JN0-363 image Question 70 50731 09182024211219000000

Referring to the exhibit, what must be included in the Route1 configuration when establishing an EBGP session with the ISP?

Become a Premium Member for full access
  Unlock Premium Member
Total 82 questions
Go to page: of 9
Open VPLUS File
Convert VPLUS to PDF

Related questions

Which two LSA types are permuted in OSPF totally stubby areas? (Choose two.)
You are asked to create connections between routing instances on the same Junos device and route between the connected Instances. What are two ways to accomplish this task? (Choose two.)
Exhibit Referring to the exhibit, which two additional steps should you lake to fully configure NSR? (Choose two.)
The segment touting SRGB start label Is 10,000 and the SRGB index range is 500. In this scenario, which two statements are correct? (Choose two.)
Which two statements are correct about the way that BGP propagates routes by default? (Choose two.)
Exhibit You are asked to assign interface xe-1/0/5 to a virtual switch. What must be accomplished to complete the configuration?
Which two statements are correct when using LDP? (Choose two.)
Which BGP attribute Is used to detect touting loops?
Exhibit You have configured graceful RE switchover (GRES), however you cannot complete the show system switchover command. Referring to the exhibit, what is the problem?
Exhibit Referring to the exhibit, how do you verify the status of the tunnel from R1?