Home

Home / Juniper / JN0-363

Juniper JN0-363 Practice Test - Questions Answers, Page 9

Question list

List of questions

Question 81

(0)

Referring to the exhibit, which statement is correct?

Question 82

(0)

Which two steps are required to enable MPLS on a physical interface in Junos? (Choose two.)

Open VPLUS File

Convert VPLUS to PDF

Related questions

The segment touting SRGB start label Is 10,000 and the SRGB index range is 500. In this scenario, which two statements are correct? (Choose two.)

Which two LSA types are permuted in OSPF totally stubby areas? (Choose two.)

Exhibit Referring to the exhibit, which two additional steps should you lake to fully configure NSR? (Choose two.)

Which two statements are correct about the way that BGP propagates routes by default? (Choose two.)

Which BGP attribute Is used to detect touting loops?

Which two statements ate correct about the BGP next-hop attribute value? (Choose two.)

Which two statements are correct when using LDP? (Choose two.)

Which OSPF database packet determines which router is in charge of the database synchronization and the transferring of LSA headers between the two systems?

Exhibit Referring to the exhibit, which two statements are correct? (Choose two.)

Exhibit The exhibit shows a topology with 1 Gbps interfaces between routers, and four RSVP LSPs operating with the respective bandwidth reservations. Which path will be selected for a new LSP from R4 to R6 with a bandwidth reservation of 400 Mbps?

Question 81

Report

Referring to the exhibit, which statement is correct?

A.

R1 will advertise only the 10.200.2.0/24 prefix to the 192.168.1.5 neighbor.

B.

R1 will advertise only the 10.200.3.0/24 prefix to the 192.168.1.5 neighbor.

C.

R1 will advertise the 10.200.1.0/24, 10.200.2.0/24, and 10.200.3.0/24 prefixes to the 192.168.1.5 neighbor.

D.

R1 will advertise only the 10.200.1.0/24 prefix to the 192.168.1.5 neighbor.

Show Answer Comment (0)

Question 82

Report

Which two steps are required to enable MPLS on a physical interface in Junos? (Choose two.)

A.

Add family mpls on the interface.

B.

Add the loopback interface under protocols mpls.

C.

Add family mpls on the loopback interface.

D.

Add the interface under protocols mpls.

Show Answer Comment (0)

Total 82 questions

First

Prev

Go to page: of 9