Cisco 300-610 Practice Test - Questions Answers, Page 3

Refer to the exhibit.

A cloud service provider deployed three geographically separated Cisco ACI data centers. One of the customers needs to host a clustered application that is spread across the three data centers. The cluster nodes that host the application need a Layer 2 topology to communicate with each other.

Which Cisco ACI topology design meets these requirements?

An engineer finishes the initial set up of a VXLAN EVPN network. The engineer is asked to plan for external connectivity that supports redundancy and extends multiple virtual routing and forwarding domains. The requirement is to use the same default gateway addressing across all leaf switches that belong to the VXLAN network.

Which two solutions must be used to meet these requirements? (Choose two.)

An engineer must configure an interface for managing and orchestrating a Cisco Nexus device. The interface must be operational if the data and control planes crash, support IPv4 and IPv6 addressing, and have access to its own VRF instance.

Which interface should be used to meet these requirements?

An engineer is implementing management access to a Cisco Nexus platform. The customer requires a solution that provides isolation between the data and control planes, in addition to management that uses encryption and authentication.

The customer will manage the device using both IPv4 and IPv6.

Which two components should be used to meet these requirements? (Choose two.)

An engineer must design a VXLAN EVPN network. The solution should optimize broadcast, unknown unicast, and multicast (BUM) and short BUM replication, and use PIM anycast RP.

Which solution should be included in the design?

A network engineer designs a Cisco Nexus data center network for a client-server farm using a pair of Nexus 9000 Series Switches in a vPC setup. Each server connects with two interfaces to both Nexus switches. The Nexus switches must always initiate the negotiation with the server.

Which feature should be used in this design to ensure traffic is forwarded from the server to the data center network?

After experiencing traffic disruptions from the failure of a single router, a customer asks an engineer to design a solution that will prevent this from occurring in the future. While examining the customer's environment, the engineer discovers that the routers are manufactured by a variety of different vendors, and they have varying amounts of CPU and memory resources. Additionally, several of the customer's applications require the ability to fine-tune the load-balancing parameters between multiple gateway routers.

Which solution should be used to meet these requirements?

An engineer must build a VXLAN flood-and-learn network. The customer requires the solution to be based on the IETF documented practice in RFC 7348. The solution must use broadcast, unknown unicast, and multicast (BUM) and include the efficient BUM and short BUM replication modes that use only shared trees.

Which technology meets these requirements?

An engineer must secure the payload traversing across the DCI. The solution must support confidentiality and integrity and it must be open standard. The solution must encrypt Ethernet frames regardless of the upper layer protocol used.

Which technology must be used to support these requirements?