ExamGecko
Login
Home / Cisco / 300-610 / List of questions
Ask Question

Cisco 300-610 Practice Test - Questions Answers, Page 4

Add to Whishlist

List of questions

Question 31

Report Export Collapse

An engineer must interconnect two geographically separated data centers. The service provider offers a Layer 2 Metro Ethernet link. The strict security policy requires that the information that is shared between two sites must be sent encrypted. The application deployed between two sites requires a line-rate throughput regardless of the packet size and speed.

Which solution meets these requirements?

L2TPv2

L2TPv2

IPsec

IPsec

MACsec

MACsec

L2TPv3

L2TPv3

Suggested answer: C
asked 07/10/2024
Adetutu Ogunsowo
49 questions

Question 32

Report Export Collapse

An engineer configured the OSPF protocol in the vPC topology. During the catastrophic failure of one of the vPC member switches, the traffic was routed to a black hole. This route was caused by the long convergence time caused by the delay of the vPC member switch reboot. After the failure, the engineer rebooted both switches, but the secondary switch powered on before the primary one. It caused all the vPCs to be shut down due to consistency-check violations.

Which two features must be used to prevent these situations from happening in the future? (Choose two.)

peer-gateway

peer-gateway

ip arp synchronize

ip arp synchronize

delay restore

delay restore

auto-recovery

auto-recovery

system priority

system priority

Suggested answer: C, D
asked 07/10/2024
Nicolas Da Silva
47 questions

Question 33

Report Export Collapse

Which two statements describe Ethernet switching mode on Cisco UCS 6100 Series Fabric Interconnects? (Choose two.)

STP runs on the uplink ports of each VLAN, as defined by PVSTP+.

STP runs on the uplink ports of each VLAN, as defined by PVSTP+.

STP runs on the uplink ports of each VLAN, as defined by MSTP.

STP runs on the uplink ports of each VLAN, as defined by MSTP.

The STP parameter configuration is unsupported.

The STP parameter configuration is unsupported.

The STP parameter configuration is supported.

The STP parameter configuration is supported.

STP runs on the server ports.

STP runs on the server ports.

Suggested answer: A, C
Explanation:

Reference: https://www.cisco.com/c/en/us/solutions/collateral/data-center-virtualization/unified-computing/whitepaper_c11-701962.html

asked 07/10/2024
Kurt Onal
48 questions

Question 34

Report Export Collapse

A Cisco UCS instance has four interfaces on a UCS VIC.

Where on the fabric interconnect does each interface terminate?

vPC

vPC

virtual interface

virtual interface

port channel

port channel

physical port

physical port

Suggested answer: B
Explanation:

Reference: https://www.cisco.com/c/dam/en/us/products/collateral/servers-unified-computing/ucs-6300-series-fabric-interconnects/cisco-unified-fabric.pdf

asked 07/10/2024
Raajhavelu Rengaraj
24 questions

Question 35

Report Export Collapse

Refer to the exhibit.

Cisco 300-610 image Question 35 113019 10072024010008000000

A Cisco UCS chassis that has two IOMs is discovered. The chassis discovery policy creates a fabric port channel.

What is the result of this policy?

Cisco UCS Manager creates two separate fabric port channels.

Cisco UCS Manager creates two separate fabric port channels.

Cisco UCS Manager creates a single fabric port channel.

Cisco UCS Manager creates a single fabric port channel.

The port channel is disabled until an administrator enables it manually.

The port channel is disabled until an administrator enables it manually.

Each uplink that connects an IOM is configured as a discrete link.

Each uplink that connects an IOM is configured as a discrete link.

Suggested answer: A
asked 07/10/2024
Sivakumar Balasundram
48 questions

Question 36

Report Export Collapse

An engineer is designing a Multichassis EtherChannel topology in which two switches must appear as a single device to a third downstream switch. Which two technologies meet this requirement? (Choose two.)

HSRP

HSRP

VSS

VSS

vPC

vPC

802.1q

802.1q

FEX

FEX

Suggested answer: B, C
Explanation:

Reference: https://www.cisco.com/c/dam/en/us/products/collateral/switches/nexus-7000-series-switches/C07-572835-00_NX-OS_vPC_DG.pdf

asked 07/10/2024
Nelson Mira
50 questions

Question 37

Report Export Collapse

What is an advantage of Cisco HyperFlex Edge as compared to Cisco HyperFlex Standard Clusters?

Cisco Intersight automatically creates an invisible cloud witness.

Cisco Intersight automatically creates an invisible cloud witness.

Cisco UCS 5108 Blade Server chassis provides SEEPROM connectivity to solve split-brain scenarios.

Cisco UCS 5108 Blade Server chassis provides SEEPROM connectivity to solve split-brain scenarios.

Cisco UCS Manager provides service profile portability across nodes.

Cisco UCS Manager provides service profile portability across nodes.

Cisco HyperFlex Edge provides native container support through the KVM hypervisor.

Cisco HyperFlex Edge provides native container support through the KVM hypervisor.

Suggested answer: A
Explanation:

Reference: https://www.cisco.com/c/dam/en/us/products/collateral/hyperconverged-infrastructure/hyperflex-hx-series/whitepaper-c11-741999.pdf

asked 07/10/2024
Yung-Shuen Chang
42 questions

Question 38

Report Export Collapse

Which approach splits a pair of clustered fabric interconnects into two standalone devices?

Run the disable fips-mode command on each fabric interconnect.

Run the disable fips-mode command on each fabric interconnect.

Run the connect local-management command on each fabric interconnect.

Run the connect local-management command on each fabric interconnect.

Erase the configuration of both fabric interconnects.

Erase the configuration of both fabric interconnects.

Unplug the Layer 1 and Layer 2 interfaces between the devices.

Unplug the Layer 1 and Layer 2 interfaces between the devices.

Suggested answer: D
asked 07/10/2024
Rudy Alexander Gonzalez
48 questions

Question 39

Report Export Collapse

Refer to the exhibit.

Cisco 300-610 image Question 39 113023 10072024010008000000

An engineer must assign multiple Fibre Channel IDs to a single port channel.

Which two features must be enabled this goal? (Choose two.)

SAN Pin Groups on the Cisco UCS Fabric Interconnects.

SAN Pin Groups on the Cisco UCS Fabric Interconnects.

NPV feature on the Cisco MDS Series.

NPV feature on the Cisco MDS Series.

end-host mode feature on the Cisco UCS Fabric Interconnects

end-host mode feature on the Cisco UCS Fabric Interconnects

NPIV feature on the Cisco MDS Series

NPIV feature on the Cisco MDS Series

Smart Zoning feature on the Cisco UCS Fabric Interconnects

Smart Zoning feature on the Cisco UCS Fabric Interconnects

Suggested answer: B, D
asked 07/10/2024
Zahid Maqsood
51 questions

Question 40

Report Export Collapse

Which type of encoding is used on 8-Gbps links as compared to 10-Gbps links?

8-Gbps links use 64B/66B encoding, and 10-Gbps links use 8B/10B encoding.

8-Gbps links use 64B/66B encoding, and 10-Gbps links use 8B/10B encoding.

8-Gbps links use 8B/10B encoding, and 10-Gbps links use 64B/66B encoding.

8-Gbps links use 8B/10B encoding, and 10-Gbps links use 64B/66B encoding.

8-Gbps links and 10-Gbps links use 8B/10B encoding.

8-Gbps links and 10-Gbps links use 8B/10B encoding.

8-Gbps links and 10-Gbps links use 64B/66B encoding.

8-Gbps links and 10-Gbps links use 64B/66B encoding.

Suggested answer: B
Explanation:

Reference: https://www.iol.unh.edu/sites/default/files/knowledgebase/10gec/10GbE_Cl49.pdf

asked 07/10/2024
Vaibhav Somani
40 questions
Total 251 questions
Go to page: of 26
Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Refer to the exhibit. A Cisco engineer is configuring a customer scenario with 2 x MDS 9000 switches 24 x UCS B200M6 blade servers. UCS 64S4 Fabric Interconnect in end-host mode and 3 x UCS 5108 server chassis with 2408 Fabric Extenders The engineer installs 6 x SQL Server 2019 on all blades and then notices that there are read and write latencies What is the best way to balance the utilization across the shared ports?
An engineer must design a solution to divide the workload across two different data centers and achieve redundancy in case of the failure of either data center Which solution must the engineer choose?
A network consultant must design a high availability interconnection of a clustered Cisco UCS Fabric Interconnect toward two upstream Layer 2 switches. The Ethernet interconnection must use all redundant links and have no impact on the STP domain size. Which connectivity solution must be used?
An engineer develops a framework for automatic repetitive tasks needed to manage a Cisco Nexus 9000 Series Switch. The engineer plans to use a programmatic interface and must keep these considerations in mind. The customer's environment requires the script to authenticate before executing further actions. The customer's security requirements mandate the use of HTTP transport. The automation team is familiar with parsing messages encoded in XML or JSON format. Which solution meets these requirements?
An engineer must implement an iSCSI storage connectivity in the existing Cisco UCS environment. The environment is based on Cisco UCS С-Series rack server, Cisco Nexus 1000V Series Switches, and VMware ESXi hosts. The implementation must meet these requirements: Provide multipathing and high availability in the event of a critical path failure. Be cost-effective and not require the purchase of new equipment. Which two components must be selected to meet these requirements? (Choose two.)
An engineer working for a private telecommunication company with an employee ID 4419 90 979 is installing a pair of Nexus 7000 Series Switches and must deploy the solution with these requirements • The environment must be separated for test and production purposes • The separation should include control, data and management plane with fault domain isolation and improved security • The test environment needs only F2 series line cards and a maximum of 256 VLANs Which set of actions meets these requirements? A. Use VRF faQUMIife environments Configure allow feature set for both VRFs Enable limit-resource vlan minimum for the test VRF
An architect needs vendor-agnostic technology to orchestrate and automate a customer network with scripts. The technology must support running ad-hoc scripts from the CLI and support a deployment of scripts based on a large, readily available set of support libraries. Which technology must the architect choose?
An engineer must design a solution based on Cisco Nexus 7709 Switches. The solution must connect test and development network segments and separate the enterprise applications from the production network. The network security team requires routing instances and the IP stack to be completely separated from each other and for traffic between the environments to undergo a deep packet inspection. The development team also requests the ability to allocate additional physical interfaces from the Cisco Nexus 7709 device in each environment. Which solution meets these requirements?
A company has added a new FCoE storage array to increase the performance of datastore access for end users. This storage array is directly connected to the Cisco Nexus 5672UP switches using four 10G port-channel interfaces. After deployment, the end users fail to access the datastore compared to the older solution. A network engineer verified the port-channel interface and finds that the congestion occurs when PFC frames are generated at the FCoE ingress interface. Which action must be taken to resolve the congestion issue?
A company data center requires a new disaster recovery solution to host critical services. The solution can sustain several hours of data loss because the services are routinely backed up to an offsite location. Also, the disaster recovery solution must provide 24-hour availability. Due to the strict policy requirements, the company wants to retain complete control of when the failover process occurs. Which solution meets these requirements?