Refer to the exhibit. Refer to the exhibits An engineer must implement a SPAN session that sends a copy of all VLAN 11 traffic on N5K_1 to the Traffic Capturing Device The configuration that is presented is already applied to the Cisco UCS Manager. Which additional action meets the objective'?

Create a LAN traffic monitoring session.

Assign the VLAN to the monitored port.

Choose VLAN 11 under the VSANs section.

Select the Clear Destination feature.

Create a LAN traffic monitoring session.

An engineer is configuring HTTPS access to Cisco UCS Manager The engineer created a keyring and created the certificate request for the keyring Cisco UCS Manager continues to receive untrusted messages from a Firefox browser and a Chrome browser Which action must be taken as the next step in the HTTPS access configuration?

Sign the certificate using the Cisco UCS Manager.

Obtain a validated certificate from Cisco

Install a trusted certificate in the browser store

A network administrator must create a Linux container on a Cisco Nexus Series Switch. The container requires 10 percent of the CPU of the switch and 1024 MB of RAM to run successfully. Which task provides the necessary resources?

Modify resource allocation with the virtual-service resize command.

Edit the container properties with the guestshell run command.

Increase the compute resources with the guestshell resize command.

Enable the Bash shell of the switch with the feature bash command

Modify resource allocation with the virtual-service resize command.

An engineer must configure a Cisco UCS blade system that is managed by Cisco UCS Manager. All four connected interfaces between the blade system and the fabric interconnects must be used. Additionally, the connectivity must tolerate any link failure between the l/O module and the fabric interconnects. Which action accomplishes these requirements?

Configure Link Group Preference to Port Channel.

Configure port aggregation with LACP policy set to default

Configure Firmware Auto Sync Server policy to Auto Acknowledge

Configure Link Group Preference to Port Channel.

Configure chassis/FEX discovery pokey action to four links

Refer to the exhibit. Refer to the exhibit. A user must be granted management access to the Cisco Nexus 9000 Series Switch using AAA servers The RADIUS servers are configured to accept login requests from the same Layer 2 subnet of the switch The user must be permitted to log in with these requirements:RADIUS server 1 must be used to log in via a console.RADIUS server 2 must be used to log in via SSH.W0hich two actions meet these requirements?

Set the RADIUS source interface to be mgmt0 for group RAD1 and VLAN 22 for group RAD2

Configure the authentication login to use group RAD1 for console and group RAD2 for remote access.

Enable command authorization to RAD1 and RAD2 for all successful logins.

Change the dead timer for RAD1 and RAD2 to 1 minute.

Set the RADIUS source interface to be mgmt0 for group RAD1 and VLAN 22 for group RAD2

Configure the authentication login to use group RAD1 for console and group RAD2 for remote access.

Refer to the exhibit. Refer to the exhibit. The gateway of Server 1 is in the VLAN 100 SVI on N5K-1 and the gateway of Server 2 is in the VLAN 200 SVI on N5K-2 Server 1 must connect to Server 2 using unidirectional traffic. Which action accomplishes this requirement?

Create a static route in VRF WEB for the subnet of Server 2 on N5K-1

Add VLAN 100 and 200 to the allowed VLANs list on the Ethernet 1/1 interface on NK5-1.

Assign VRF WEB membership to interfaces VLAN 150 and 200 on N5K-2.

Configure access VLAN 100 on interface Ethernet 1/2 on N5K-2.

Create a static route in VRF WEB for the subnet of Server 2 on N5K-1

Refer to the exhibit. Refer to the exhibit. An engineer is creating a SPAN session to send a copy of all the Fabric-A VSAN 11 traffic on NSK_1 to the monitoring laptop. The configurator that is presented has already been applied to Cisco UCS Manager. Which action complts the configuration?

Select VSAN 11 as the source of traffic.

Activate a NetFlow monitoring session

Create a SAN traffic rnonitoring session

Set VLAN 11 as the traffic destination

Select VSAN 11 as the source of traffic.

An engineer must implement protection against ICMP DoS attacks on a Cisco Nexus 9000 Series Switch. The requirement is to rate-limit ICMP without denying all other ICMP traffic. The ICMP trafic currently passing through the Cisco Nexus 9000 device must not be affected. Which configuration accomplishes these goals?

Apply a control plane service policy that matches all ICMP traffic to drop the traffic fiat exceeds the threshold.

Configure SNMP traps to send the ICMP notification if the CPU utilization is more than 90%.

Reconfigure the Layer 3 interfaces to be in the non-default VRF and ICMP broadcast storm control

Create an access list to deny ICMP traffic and apply it to all interlaces in the inside direction.

Apply a control plane service policy that matches all ICMP traffic to drop the traffic fiat exceeds the threshold.

Cisco 350-601 Practice Test 9 - Free Online Exam Prep & Questions

A bridge domain is being extended out of a Cisco ACI fabric. Between which of these components are policies used to identify the connectivity between Endpoint Groups and the external connection?

Become a Premium Member for full access

Unlock Premium Member

Cisco 350-601 Practice Test 9

Question

Cisco 350-601 Practice Tests

Practice Tests