Cisco 350-801 Practice Test - Questions Answers, Page 2
Question list
List of questions
Related questions
Which transport protocol does the application layer protocol SNMP use?
HTTP
XML
UDP
SIP
Which description of the Mobile and Remote Access feature is true?
Collaboration Edge feature that enables remote individuals to perform international calls from Jabber with a VPN connection
Collaboration Edge feature that enables remote individual to access enterprise collaboration services via Jabber with the use of a VPN connection
Collaboration Edge feature that enables remote individuals to access enterprise collaboration services via Jabber without the use of a VPN connection
Collaboration Edge feature that enables remote individuals to access all enterprise collaboration services using a PC within the corporate environment
What causes poor voice quality and video pixelization in a video call?
Cisco Unified Communications Manager is configured to use G.711 instead G.729.
1 Gbps network ports are used instead of 100 Mbps network ports.
The QoS is configured incorrectly.
A firewall is blocking the RTP ports.
A presence redundancy group is deployed, and an engineer with ID012345678 initiates a Manager fallback. Which statement about Cisco server Recovery Manager is true?
restart the Cisco Presence Engine
disconnects all user that had been failed over
restarts critical services on the secondary node
disconnects all users that had been failed over, and the users must log in again
Which statement describes the outcome when the trust boundary is defined at the Cisco IP phone?
Packets or Ethernet frames are not remarked by the IP phone.
Packets or Ethernet frames are remarked at the distribution layer switch.
Packets of Ethernet frames are remarked at the access layer switch.
Packets of Ethernet frames are not remarked at the access layer switch.
Which method is used to avoid toll fraud with Cisco Unified Communications Manager calls?
Call policy service
Default zone access rules
TOLLFRAUD_APP
class of service
An engineer is notified that the Cisco TelePresence MX800 that is registered in Cisco Unified communications Manager shows an empty panel, and the Touch 10 shows a corresponding icon with no action when pressed. Where does the engineer go to remove the inactive custom panel?
The phone configuration page in CUCM Administration
The SIP Trunk security profile page in CUCM Administration
The software Upgrades page in CUCM OS Administration
The In-Room control Editor on the webpage of the MX800
Which action prevent toll fraud in Cisco Unified Communications Manager?
Configure ad hoc conference restriction.
Implement toll fraud restriction in the Cisco IOS router.
Allow off-net to off-net transfers.
Implement route patterns in Cisco Unified CM.
Which wildcard must an engineer configure to match a whole domain in SIP route patterns?
*
@
.
!
Refer to the exhibit.
What is a possible cause of the PRI issue?
The cable is unplugged.
The controller shut down.
The clock source is incorrect.
The framing is configured incorrectly
Question