Cisco 350-801 Practice Test - Questions Answers, Page 25

List of questions
Question 241

Refer to the exhibit.
A collaboration engineer needs to replace the original, single NTP server that was configured during the initial install of a Cisco UCM server What is the first step to accomplish this task?
Question 242

An administrator executes the debug isdn q931 command while debugging a failed call. After a test call is placed, the logs return a disconnect cause code of 1. What is the cause of this problem?
Question 243

Refer to the exhibit.
There is a call flow between Phone A and Phone B Phone B (holder) places Phone A (holder) on hold Which MRGL and Audio Source are played to Phone A?
Question 244

A SIP phone has been configured in the system with MAC address 0030 96D2 D5CB The phone retrieves the configuration file from the Cisco UCM. Which naming format is the file that is downloaded?
Question 245

Where in Cisco UCM are codec negotiations configured for endpoints?
Question 246

Refer to the exhibit.
A call from +1 613 555 1234 that is sent out through the Nice Gateways should result in a calling party of 001 613 555 1234 with the numbering type "international" Which configuration accomplishes this goal?
Question 247

Refer to the exhibit.
Unanswered calls do not reach the voicemail associated with the phones Instead, callers receive the default greeting Which action fixes the configuration?
Question 248

Callers from a branch report getting busy tones intermittently when trying to reach colleagues in other office branches during peak hours An engineer collects Cisco CallManager service traces to examine the situation. The traces show:
What should be fixed to resolve the issue?
Question 249

An engineer implements a new Cisco UCM based telephony system per these requirements:
β’ The local Ethernet bandwidth is sized based on the total bandwidth per call β’ A G.736 codec is used.
β’ The bit rate is 64 kbps
β’ The codec sample interval is 10 ms.
β’ The voice payload size is 160 bytes per 20 ms.
What should the size of the Ethernet bandwidth be per call?
Question 250

Refer to the exhibit.
A collaboration engineer configures Cisco UCM to act as a DHCP server What must be done next to configure the DHCP server?
Question