Cisco 350-801 Practice Test - Questions Answers, Page 8
Question list
List of questions
Related questions
Which packet delay is the maximum supported between Cisco Unified Communications Manager nodes for clustering over WAN deployments?
80 ms round trip
40 ms round trip
510 ms round trip
150 ms round trip
An engineer configures local route group names to simplify a dial plan. Where does the engineer set the route group according to the local route group names that are configured?
CSS
device pool
route list
route pattern
Regarding SIP integrations with Cisco Unified Communications Manager, if the Cisco Unity Connection is configured to listen for incoming IPv4 and IPv6 traffic, how should the addressing mode be set up in the Cisco Unity Connection?
Set up media ports for each port group to use IPv4.
Set up for each group to use IPv4 and IPv6.
Set up IPv4 and IPv6 in cisco Unified CM.
Set up is not required.
What is a characteristic of video traffic that governs QoS requirements for video?
Video is typically constant bit rate.
Voice and video are the same, so they have the same QoS requirements.
Voice and video traffic are different, but they have the same QoS requirements.
Video is typically variable bit rate.
A Cisco Telepresence SX80 suddenly has issues displaying main video to a display over HDMI. Which command can you use from the SX80 admin CLI to check the video output status to the monitor?
xStatus HDMI Output
xStatus video Output
xconfiguration video Output
xcommand video status
Which two protocols does Cisco IM and Presence use to authenticate Jabber? (Choose two.)
TCP
SOAP
AXL
XMPP
QBE
Which Cisco Unified communications manager configuration is required for SIP MWI integration?
Select "Redirecting Diversion Header Delivery – Inbound" on the SIP trunk.
Enable "Accept presence subscription" on the SIP trunk security profile.
Select "Redirecting Diversion Header Delivery – outbound" on the SIP trunk.
Enable "Accept unsolicited notification" on the SIP Trunk security profile.
An engineer encounters third-party devices that do not support Cisco Discovery Protocol. What must be configured on the network to allow device discovery?
TFTP
LACP
LLDP
SNMP
A customer wants a video conference with five Cisco TelePresence IX5000 series system. Which media resource is necessary in the design to fully utilize the immersive functions?
Software conference bridge on Cisco Unified Communications Manager
Cisco PVDM4-128
Cisco Webex meetings server
Cisco meeting server
How does Cisco Unified Communications Manager perform a digit analysis on-hook versus off-hook for an outbound call from a Cisco IP phone that is registered to Cisco Unified CM?
On-hook, by pressing the digits and entering "#" to process the call, Unified CM performs a digitby- digit analysis; off-hook, Unified CM analyses all digits as a string.
On-hook, unified CM performs a digit-by-digit analysis; off-hook, Unified CM considers all digit were dialed and dos not wait for additional digits.
On-hook, no digit analysis is performed; off-hook, Unified CM requires the "#" to start the digit analysis.
On-hook, Unified CM considers all digits were dialed and does not wait for additional digits; offhook, Unified CM performs a digit-by-digit analysis.
Question