A network engineer is configuring OSPF on a router. The engineer wants to prevent having a route to 177.16.0.0/16 learned via OSPF. In the routing table and configures a prefix list using the command ip prefix-list OFFICE seq S deny172.16.0.0/16. Winch two identical configuration commands must be applied to accomplish the goal? (Choose two.)

distribute-list prefix OFFICE in under the OSPF process

Ip prefix-list OFFICE seq 10 permit 0.0.0.0/0 Ie 32

distribute-list prefix OFFICE in under the OSPF process

Ip prefix-list OFFICE seq 10 permit 0.0.0.0/0 Ie 32

ip prefix-list OFFICE seq 10 permit 0.0.0.0/0 ge 32

distribute-list OFFICE out under the OSPF process

distribute-list OFFICE in under the OSPF process

Which function does a fabric wireless LAN controller perform In a Cisco SD-Access deployment?

manages fabric-enabled APs and forwards client registration and roaming information to the Control Plane Node

coordinates configuration of autonomous nonfabric access points within the fabric

performs the assurance engine role for both wired and wireless clients

is dedicated to onboard clients in fabric-enabled and nonfabric-enabled APs within the fabric

What is a TLOC in a Cisco SD-WAN deployment?

component set by the administrator to differentiate similar nodes that offer a common service

value that identifies a specific tunnel within the Cisco SD-WAN overlay

identifier that represents a specific service offered by nodes within the Cisco SD-WAN overlay

attribute that acts as a next hop for network prefixes

component set by the administrator to differentiate similar nodes that offer a common service

What are the main components of Cisco TrustSec?

Cisco ISE. network switches, firewalls, and routers

Cisco ISE and Enterprise Directory Services

Cisco ISE. network switches, firewalls, and routers

Cisco ASA and Cisco Firepower Threat Defense

Refer to the exhibit. An engineer must set up connectivity between a campus aggregation layer and a branch office access layer. The engineer uses dynamic trunking protocol to establish this connection, however, management traffic on VLAN1 is not passing.Which action resolves the issue and allow communication for all configured VLANs?

Configure the correct native VLAN on the remote interface

Allow all VLANs on the trunk links

Disable Spanning Tree for the native VLAN.

Configure the correct native VLAN on the remote interface

Change both interfaces to access ports.

Which Cisco FlexConnect state allows wireless users that are connected to the network to continue working after the connection to the WLC has been lost?

Authentication- Down/Switch-Local

Authentication Down/Switching Down

Authentication-Central/Switch-Local

Authentication- Down/Switch-Local

Authentication-Central/Switch-Central

What is the purpose of an RP in PIM?

send join messages toward a multicast source SPT

ensure the shortest path from the multicast source to the receiver

receive IGMP joins from multicast receivers

secure the communication channel between the multicast sender and receiver

Refer to the exhibit. What is the result of the API request?

The "params" variable reads data fields from the network appliance

The "params" variable sends data fields to the network appliance.

The native interface information is read from the network appliance.

The Information for all interfaces is read from the network appliance.

The "params" variable reads data fields from the network appliance

Which definition describes JWT in regard to REST API security?

an encoded JSON token that is used for authentication

an encrypted JSON token that is used for authentication

an encrypted JSON token that is used for authorization

an encoded JSON token that is used to securely exchange information

an encoded JSON token that is used for authentication

What happens when a FlexConnect AP changes to standalone mode?

All controller-dependent activities stop working except the DFS.

All client roaming continues to work

Only clients on central switching WLANs stay connected.

All clients on an WLANs are disconnected

Which benefit is realized by implementing SSO?

minimal network downtime following an RP switchover

communication between different nodes for cluster setup

minimal network downtime following an RP switchover

Refer to the exhibit. The administrator troubleshoots an EtherChannel that keeps moving to err-disabled. Which two actions must be taken to resolve the issue? (Choose two.)

Ensure that interfaces Gi1/0/2 and Gi1/0/3 connect to the same neighboring switch.

Ensure that the neighbor interfaces of Gi1/0/2 and Gi/0/3 are configured as members of the same EtherChannel

Reload the switch to force EtherChannel renegotiation

Ensure that interfaces Gi1/0/2 and Gi1/0/3 connect to the same neighboring switch.

Ensure that the switchport parameters of Port channel1 match the parameters of the port channel on the neighbor switch

Ensure that the corresponding port channel interface on the neighbor switch is named Portchannel1.

Ensure that the neighbor interfaces of Gi1/0/2 and Gi/0/3 are configured as members of the same EtherChannel

What Is the difference between the MAC address table and TCAM?

Router prefix lookups happen in TCAM. MAC address table lookups happen In CAM.

The MAC address table supports partial matches. TCAM requires an exact match.

The MAC address table is contained in TCAM ACL and QoS information is stored in CAM.

Router prefix lookups happen in TCAM. MAC address table lookups happen In CAM.

TCAM is used to make L2 forwarding decisions. CAM is used to build routing tables

How do EIGRP metrics compare to OSPF metrics?

EIGRP metrics are based on a combination of bandwidth and packet loss, and OSPF metrics are based on interface bandwidth.

EIGRP uses the Dijkstra algorithm, and OSPF uses The DUAL algorithm

The EIGRP administrative distance for external routes is 170. and the OSPF administrative distance for external routes is undefined

The EIGRP administrative distance for external routes is 170. and the OSPF administrative distance for external routes is 110

Refer to the exhibit. A network engineer must log in to the router via the console, but the RADIUS servers are not reachable Which credentials allow console access1?

the username "cisco" and the password "cisco123"

the username "cisco" and the password "Cisco"

no username and only the password "test123"

no username and only the password "cisco123"

the username "cisco" and the password "cisco123"

What Is a characteristic of a WLC that is in master controller mode?

All new APs that join the WLAN are assigned to the master controller.

All wireless LAN controllers are managed by the master controller.

All new APs that join the WLAN are assigned to the master controller.

Configuration on the master controller is executed on all wireless LAN controllers.

The master controller is responsible for load balancing all connecting clients to other controllers

An engineer must configure an ACL that permits packets which include an ACK in the TCP header Which entry must be included in the ACL?

access-list 110 permit tcp any any eq 21 established

access-list 10 permit ip any any eq 21 tcp-ack

access-list 110 permit tcp any any eq 21 tcp-ack

access-list 10 permit tcp any any eq 21 established

access-list 110 permit tcp any any eq 21 established

What is one characteristic of the Cisco SD-Access control plane?

It stores remote routes in a centralized database server

It is based on VXLAN technology.

Each router processes every possible destination and route

It allows host mobility only in the wireless network.

It stores remote routes in a centralized database server

Cisco 350-401 Practice Test 10 - Free Online Exam Questions 361-400

Refer to the exhibit.

Cisco 350-401 image Question 361 115660 10102024232943000000

R1 is able to ping the R3 fa0/1 Interface. Why do the extended pings fail?

Become a Premium Member for full access

Unlock Premium Member

Cisco 350-401 Practice Test 10

Question

Cisco 350-401 Practice Tests

Practice Tests