How does NETCONF YANG represent data structures?

as strict data structures denned by RFC 6020

What is a characteristic of the overlay network in the Cisco SD-Access architecture?

It provides isolation among the virtual networks and independence from the physical network.

It uses a traditional routed access design to provide performance and high availability to the network.

It consists of a group of physical routers and switches that are used to maintain the network.

It provides isolation among the virtual networks and independence from the physical network.

It provides multicast support to enable Layer 2 Hooding capability in the underlay network.

An administrator is configuring NETCONF using the following XML string. What must the administrator end the request with?

Refer to the exhibit. The port channel between the switches does not work as expected. Which action resolves the issue?

interface Gi0/1 on Switch2 must be configured as active.

Interface Gi0/0 on Switch2 must be configured as passive.

Interface Gi0/1 on Switch1 must be configured as desirable.

interface Gi0/1 on Switch2 must be configured as active.

Trucking must be enabled on both Interfaces on Switch2.

Refer to the exhibit. What is the effect of introducing the sampler feature into the Flexible NetFlow configuration on the router?

CPU and memory utilization are reduced when compared with what is required for full NetFlow.

NetFlow updates to the collector are sent 50% less frequently.

Every second IPv4 packet is forwarded to the collector for inspection.

CPU and memory utilization are reduced when compared with what is required for full NetFlow.

The resolution of sampling data increases, but it requires more performance from the router.

Reter to the exhibit. An administrator troubleshoots intermittent connectivity from internal hosts to an external public server. Some internal hosts can connect to the server while others receive an ICMP Host Unreachable message and these hosts change over time. What is the cause of this issue?

The NAT ACL does not match alt internal hosts

The translator does not use aOdress overloading

The NAT ACL does not match alt internal hosts

The NAT ACL and NAT pool share the same name

The NAT pool netmask rs excessively wide

Reter to the exhibit. Refer to the exhibit. What is achieved by this code?

It displays the loopback interface

It unshuts the loopback interface

It renames the loopback interface

It deletes the loopback interface

It displays the loopback interface

An engineer must configure an EXEC authorization list that first checks a AAA server then a local username. If both methods fail, the user is denied. Which configuration should be applied?

aaa authorization exec default group radius local

aaa authorization exec default local group tacacs+

aaa authorization exec default local group radius none

aaa authorization exec default group radius local none

aaa authorization exec default group radius local

What is a characteristics of a vSwitch?

enables VMs to communicate with each other within a virtualized server

supports advanced Layer 3 routing protocols that are not offered by a hardware switch

enables VMs to communicate with each other within a virtualized server

has higher performance than a hardware switch

operates as a hub and broadcasts the traffic toward all the vPorts

What is a characteristic of a Type I hypervisor?

It is completely independent of the operating system.

It is installed on an operating system and supports other operating systems above it.

It is referred to as a hosted hypervisor.

Problems in the base operating system can affect the entire system.

It is completely independent of the operating system.

Which two characteristics apply to the endpoint security aspect of the Cisco Threat Defense architecture? (Choose two.)

outbound URL analysis and data transfer controls

blocking of fileless malware in real time

detect and black ransomware in email attachments

outbound URL analysis and data transfer controls

blocking of fileless malware in real time

cloud-based analysis of threats

What does the number in an NTP stratum level represent?

The number of hops it takes to reach the authoritative time source.

The number of hops it takes to reach the master time server.

The number of hops it takes to reach the authoritative time source.

The amount of offset between the device clock and true time.

The amount of drift between the device clock and true time.

Refer to the exhibit. An engineer entered the command no spanning-tree bpduguard enable on interface Fa 1/0/7. What is the effect of this command on Fa 1/0/7?

It remains in err-disabled state until the shutdown/no shutdown command is entered in the interface configuration mode.

It remains in err-disabled state until the errdisable recovery cause failed-port-state command is entered in the global configuration mode.

It remains in err-disabled state until the no shutdown command is entered in the interface configuration mode.

It remains in err-disabled state until the spanning-tree portfast bpduguard disable command is entered in the interface configuration mode.

How does SSO work with HSRP to minimize network disruptions?

It enables HSRP to failover to the standby RP on the same device.

It enables HSRP to elect another switch in the group as the active HSRP switch.

It ensures fast failover in the case of link failure.

It enables data forwarding along known routes following a switchover, white the routing protocol reconverges.

It enables HSRP to failover to the standby RP on the same device.

What is one characteristic of VXLAN?

It supports multitenant segments.

It supports a maximum of 4096 VLANs.

It supports multitenant segments.

It uses STP to prevent loops in the underlay network.

It uses the Layer 2 header to transfer packets through the network underlay.

In which two ways does the routing protocol OSPF differ from EIGRP? (Choose two.)

OSPF supports an unlimited number of hops. EIGRP supports a maximum of 255 hops.

OSPF supports only equal-cost load balancing. EIGRP supports unequal-cost load balancing.

OSPF supports an unlimited number of hops. EIGRP supports a maximum of 255 hops.

OSPF provides shorter convergence time than EIGRP.

OSPF is distance vector protocol. EIGRP is a link-state protocol.

OSPF supports only equal-cost load balancing. EIGRP supports unequal-cost load balancing.

OSPF supports unequal-cost load balancing. EIGRP supports only equal-cost load balancing.

Refer to the exhibit. Refer to the exhibit. Traffic is not passing between SW1 and SW2. Which action fixes the issue?

Configure PAgP mode on S1 to desirable.

Configure LACP mode on S1 to passive.

Configure switch port mode to ISL on S2.

Configure PAgP mode on S1 to desirable.

Configure LACP mode on S1 to active.

Which router is elected the IGMP Querier when more than one router is in the same LAN segment?

The router with the lowest IP address

The router with the shortest uptime

The router with the lowest IP address

The router with the highest IP address

The router with the longest uptime

In Cisco DNA Center, what is the integration API?

westbound interface, which allows the exchange of data to be used by ITSM. IPAM and reporting

southbound consumer-facing RESTful API. which enables network discovery and configuration management

westbound interface, which allows the exchange of data to be used by ITSM. IPAM and reporting

an interface between the controller and the network devices, which enables network discovery and configuration management

northbound consumer-facing RESTful API, which enables network discovery and configuration management

A customer wants to connect a device to an autonomous Cisco AP configured as a WGB. The WGB is configured properly: however, it fails to associate to a CAPWAP- enabled AP. Which change must be applied in the advanced WLAN settings to resolve this issue?

Disable FlexConnect local switching.

Refer to the exhibit. Refer to the exhibit. Which command filters the ERSPAN session packets only to interface GigabitEthernet1?

source interface gigabitethernet1 ip 10.10.10.1

Cisco 350-401 Practice Test 12 - Free Online Exam Prep & Questions

Question 1 / 40

Which method displays text directly into the active console with a synchronous EEM applet policy?

event manager applet boom event syslog pattern 'UP' action 1.0 gets 'logging directly to console'

event manager applet boom event syslog pattern 'UP' action 1.0 syslog priority direct msg 'log directly to console'

event manager applet boom event syslog pattern 'UP' action 1.0 puts 'logging directly to console'

event manager applet boom event syslog pattern 'UP' action 1.0 string 'logging directly to console'

Comment (0)

Cisco 350-401 Practice Test 12

Question

Cisco 350-401 Practice Tests

Practice Tests