Refer to the exhibit. Refer to the exhibit. An engineer configures HSRP and enters the show standby command. Which two facts about the network environment are derived from the output? (Choose two.)

The virtual IP address of the HSRP group is 10.1.1.1.

If a router with a higher IP address and same HSRP priority as the active router becomes available, that router becomes the new active router 5 seconds later.

The local device has a higher priority selling than the active router

The virtual IP address of the HSRP group is 10.1.1.1.

If the local device fails to receive a hello from the active router for more than 5 seconds, it becomes the active router.

The hello and hold timers are set to custom values.

If a router with a higher IP address and same HSRP priority as the active router becomes available, that router becomes the new active router 5 seconds later.

Refer to the exhibit. The OSPF neighborship fails between two routers. What is the cause of this issue?

There is an MTU mismatch between the two routers.

The OSPF router ID is missing on this router.

The OSPF process is stopped on the neighbor router.

There is an MTU mismatch between the two routers.

The OSPF router ID is missing on the neighbor router.

Which function does a Cisco SD-Access extended node perform?

used to extend the fabric connecting to downstream nonfabric enabled Layer 2 switches

provides fabric extension to nonfabric devices through remote registration and configuration

performs tunneling between fabric and nonfabric devices to route traffic over unknown networks

used to extend the fabric connecting to downstream nonfabric enabled Layer 2 switches

in charge of establishing Layer 3 adjacencies with nonfabric unmanaged node

What is the function of vBond in a Cisco SD-WAN deployment?

onboarding of SD-WAN routers into the SD-WAN overlay

initiating connections with SD-WAN routers automatically

pushing of configuration toward SD-WAN routers

onboarding of SD-WAN routers into the SD-WAN overlay

gathering telemetry data from SD-WAN routers

When using BFD in a network design, which consideration must be made?

BFD is used with dynamic routing protocols to provide subsecond convergence.

BFD is used with first hop routing protocols to provide subsecond convergence.

BFD is more CPU-intensive than using reduced hold timers with routing protocols.

BFD is used with dynamic routing protocols to provide subsecond convergence.

BFD is used with NSF and graceful to provide subsecond convergence.

Cisco 350-401 Practice Test 13 - Free Online Exam Prep & Questions

An engineer is describing QoS to a client. Which two facts apply to traffic policing? (Choose two.)

Become a Premium Member for full access

Unlock Premium Member

Cisco 350-401 Practice Test 13

Question

Cisco 350-401 Practice Tests

Practice Tests