Cisco 300-410 Practice Test - Questions Answers, Page 58

List of questions
Question 571

Refer to the exhibit.
Refer to the exhibit The R2 OSPF route 10 2 2 0/24 shows in the R1 EIGRP routing table without route redistribution performed between OSPF and EIGRP routing protocols Which configuration is required on router R2 to resolve the issue?
Question 572

Refer to the exhibit.
Refer to the exhibit Which action fixes the OSPF routes redistribution into EIGRP?
Question 573

Refer to the exhibit.
Refer to the exhibit An engineer investigates an IPv6 EIGRP neighbor adjacency issue that sees the neighbors flapping and issued a ping from R1 to its directly connected neighbor. The link between the switches is stable at Layer 2. and other connected devices are also functioning. Which action resolves the issue?
Question 574

Refer to the exhibit.
Refer to the exhibit. Which two configurations are required on R2 to prevent a routing loop caused by the redistribution from OSPF back into EIGRP? (Choose two.)
Question 575

Refer to the exhibit.
Refer to the exhibit. R1 and R2 have been configured where the neighbor relationship must be authenticated usmg MD5:
The neighbor relationship is not coming up. Which configuration resolves the issue?
Question 576

Refer to the exhibit.
Refer to the exhibit. R3 is dual-homed to two service providers for traffic redundancy. R3 prefers its outbound traffic via R2. Which set of configurations achieves this goal?
Question 577

Refer to the exhibit.
Refer to the exhibit. The primary link between R1 and R2 went down but R3 is still advertising the 192.166.200.0/24 network to R1 and the 192.166.100.0/24 network to R2, which creates a loop. Which action resolves the issue?
Question 578

Refer to the exhibit.
Refer to the exhibit. Router ABR-Rtr is not propagating the internet routes in OSPF area 10. which causes internet reachability problems in the are a. Which action resolves the issue?
Question 579

Refer to the exhibit.
Refer to the exhibit. R1 is directly connected to R2 over network 10.100.14.0/24. An engineer configures R1 to advertise a static route that is connected to a local loopback for network 10.100.13.0/24. The network is not in the routing table of R2. Which action resolves the issue?
Question 580

Refer to the exhibit.
Reler Io the exhibit The engineer is trying to transfer the new IOS file to the router R3 but is getting an error Which configuration achieves the file transfer?
Question