Cisco 350-401 Practice Test - Questions Answers, Page 43
Question list
List of questions
Related questions
Reter to the exhibit.
An engineer configures the trunk and proceeds to configure an ESPAN session to monitor VLANs10.
20. and 30. Which command must be added to complete this configuration?
Device(config.mon.erspan.stc)# no filter vlan 30
Devic(config.mon.erspan.src-dst)# no vrf 1
Devic(config.mon.erspan.src-dst)# erspan id 6
Device(config.mon-erspan.Src-dst)# mtu 1460
By default, which virtual MAC address Goes HSRP group 25 use?
05:5c:5e:ac:0c:25
04:16:6S:96:1C:19
00:00:0c:07:ac:19
00:00:0c:07:ac:25
Reter to the exhibit.
What is the JSON syntax that is formed the data?
{'Name'';''Bob johnon';''Age': Sevenfive,''Alive'': true,''FavoriteFoods';[''Cereal';''Mustard';''Onions'}}
{'Name'':''Bob johnon':''Age': 75 ''Alive'': true,''Favorite Foods';[''Cereal';''Mustard';''Onions'}}
{'Name'':''Bob johnon':''Age: 75,''Alive: true, FavoriteFoods;[Cereal, Mustard';''Onions}}
{'Name'': 'Bob johnon','Age': 75,'Alive': true,''FavoriteFoods': 'Cereal';'Mustard','Onions'}}
Refer to the exhibit.
What are two effect of this configuration? (Choose two.)
Inside source addresses are translated to the 209.165.201.0/27 subnet.
It establishes a one-to-one NAT translation.
The 10.1.1.0/27 subnet is assigned as the inside global address range.
The 209.165.201.0/27 subnet is assigned as the outside local address range.
The 10.1.1.0/27 subnet is assigned as the inside local addresses.
In a Cisco Catalyst switch equipped with two supervisor modules an administrator must temporally remove the active supervisor from the chassis to perform hardware maintenance on it. Which mechanism ensure that the active supervisor removal is not disruptive to the network operation?
NSF/NSR
SSO
HSRP
VRRP
A company requires a wireless solution to support its mam office and multiple branch locations. All sites have local Internet connections and a link to the main office lor corporate connectivity. The branch offices are managed centrally.
Which solution should the company choose?
Cisco United Wireless Network
Cisco DNA Spaces
Cisco Catalyst switch with embedded controller
Cisco Mobility Express
Which Python snippet should be used to store the devices data structure in a JSON file?
Which type of tunnel Is required between two WLCs to enable Intercontroller roaming?
mobility
LWAPP
CAPWAP
iPsec
Reter to the exhibit.
Refer to the exhibit. Which configuration must be added to enable GigabitEthemet 0/1 to participate in OSPF?
SF_router (config-router)# network 10.10.1.0 0.0.0.255 area 0
SF_rouier (conng)# network 10.10.1.0 0.0.0.255 area 1
SF_router (conflg-routerp) network 10.10.1.0 0.0.0.255 area 1
SF_rouler (contlg-rouler)# network 10.10.1.0 255.255.255.0 area 0
Reter to the exhibit.
Refer to the exhibit. A network engineer checks connectivity between two routers. The engineer can ping the remote endpoint but cannot see an ARP entry. Why is there no ARP entry?
The ping command must be executed in the global routing table.
Interface FastEthernet0/0 Is configured in VRF CUST-A, so the ARP entry is also in that VRF.
When VRFs are used. ARP protocol must be enabled In each VRF.
When VRFs are used. ARP protocol is disabled in the global routing table.
Question