Cisco 350-401 Practice Test - Questions Answers, Page 89
Question list
List of questions
Related questions
An engineer must configure a new WLAN 802.11r and requires users to enter a passphrase. What must be configured to support this requirement?
802.1X and Fast Transition
FT PSK and Fast Transition
802.1X and SUITEB-1X
FT PSK and SUITEB-1X
A customer has two Cisco WLCs that manage separate APs throughout a building. Each WLC advertises the same SSID but terminates on different interfaces. Users report that they drop their connections and change IP addresses when roaming. Which action resolves this issue?
Enable client toad balancing.
Enable fast roaming.
Configure high availability.
Configure mobility groups.
To which category does a REST API that has been developed for IP address management integration belong?
southbound
eastbound
northbound
westbound
Which Cisco SD-WAN component authenticates the routers and the vSmart controllers?
vBond orchestrator
vManage NMS
vAnalytics
vEdge
How does policy-based routing function?
It schedules traffic using classification
It is applied to all ingress unicast traffic received on an interlace
It is applied to all egress unicast traffic on an interface
It controls traffic using embedded event detectors
What are two characteristics of a directional antenna? (Choose two.)
high gain
receive signals equally-from all directions
commonly used to cover large areas
provides the most focused and narrow beam width
low gain
Refer to the exhibit.
Which type of antenna do the radiation patterns present?
Patch
Omnidirectional
Yagi
Dipole
DRAG DROP
Drag and drop the characteristics from the left onto the corresponding orchestration tool on the right.
Which control plane protocol is used between Cisco SD-WAN routers and vSmart controllers?
TCP
OMP
UDP
BGP
Refer to the exhibit.
Refer to the exhibit. The DevOps team noticed missing NetFlow data during peak utilization times for remote branches. Which configuration allows for this issue to be minimized or resolved?
Configure NetFlow on the in and outbound directions.
Change the transport type from UDP to TCP.
Configure long byte counters when specifying a flow record.
Change the flow monitor to IPv6 from IPv4.
Question