Cisco 350-501 Practice Test - Questions Answers, Page 10
Question list
List of questions
Related questions
Refer to the exhibit:
Which two statements about the ISIS topology are true? (Choose two.)
All four routers are operating as Level 1 routers only.
All four routers are operating as Level 2 routers only.
All four routers are operating as Level 1-2 routers.
R1 and R2 are Level 2 neighbors.
R1 and R4 are Level 2 neighbors
Refer to the exhibit:
A network engineer is implementing QoS services. Which two statements about the QoS-group keyword on Cisco IOS XR 3re true? (Choose two )
The QoS group numbering corresponds to priority level
QoS group marking occurs on the ingress
It marks packets for end to end QoS pokey enforcement across the network
QoS group can be used in fabric QoS policy as a match criteria
It cannot be used with priority traffic class
Refer to the exhibit:
If router A is the RP, which PIM mode can you configure so that devices will send multicast traffic toward the RP?
PIM-SM
PI MM-DM
BIDIR-PIM
PIM-SSM
Refer to the exhibit:
Which purpose of implementing NSF with this configuration is true?
The router uses NSF to load balance traffic between two links, with the primary link alternating every 90 seconds
The router uses NSF to reduce neighbor-relationship downtime during RP switchover
The router uses NSF to load balance traffic on a routed EtherChannel
The router uses NSF to handle RP switchover while allowing neighbor relationships to remain up
ASN 65001 is peering with ASN 65002 to exchange IPv6 BGP routes. All routes that originate in ASN 65001 have a standard community value of 65001:100, and ASN 65002 is allowed to advertise only 2001 :db8:aaaa::/48. An engineer needs to update the ASN 65001 route-filtering configuration to meet these conditions:
* Looped routes into ASN 65001 and routes that have traversed 10 or more ASNs must be denied.
* Routes accepted into ASN 65001 must be assigned a community value of 65001:200.
Which configuration must the engineer apply to the ASN 65001 border router?
Option A
Option B
Option C
Option D
Option E
Refer to the exhibit.
Which task completes the configuration?
Specify the maximum number of prefixes that R1 receives from neighbor 192.168.1.2.
Specify the source interface in the neighbor statement.
Specify the activate neighbor 192.168.1.2 under the IPv4 address family.
Specify the local-as value in the neighbor statement.
Refer to the exhibit.
Router 1 is missing the route for the router 2 loopback 0. What should the engineer change to fix the problem?
the area numbers on Router 1 and Router 2 to be similar
the wildcard mask network statement in OSPF of Router 2
Router 1 to be an ABR
the hello timers on Router 1 and Router 2 to be different
What is a role of NSO?
It automates the deployment of access points with its built-in wireless LAN controller.
It manages WAN infrastructure using a virtual switch.
It provides full lifecycle management of a device.
It resides on a hypervisor that runs the Windows OS.
Which utility must be used to locate MPLS faults?
QoS
MPLS LSP ping
MPLStraceroute
EEM
Refer to the exhibit.
A network engineer with an employee id: 3812:12:993 has started to configure router R1 for IS-IS as shown. Which additional configuration must be applied to configure the IS-IS instance to advertise only network prefixes associated to passive interfaces?
Option A
Option B
Option C
Option D
Question