Cisco 350-501 Practice Test - Questions Answers, Page 14

Refer to the exhibit.

An engineer is configuring router R1 for OSPFv3 as shown. Which additional configuration must be performed so that the three active interfaces on the router will advertise routes and participate in OSPF IPv6 processes?

Refer to the exhibit.

An engineer is updating this network to meet these conditions:

• Area 10 will receive inter-area routes and support mutual redistribution of external routes with the extranet.

• The ::/0 route is prohibited in Area 10.

• Area 11 will receive only the ::/0 route from the ABR.

• External route redistribution is not supported in Area 11.

• The ABR in Area 11 will advertise no interarea routes.

Which two configurations must be performed to meet the requirements? (Choose two.)

Refer to the exhibit.

An engineer needs to implement this QoS policy on customer's network due to ongoing slow network issues. What will be the effect on the network when the engineer implements this configuration?

While implementing TTL security, an engineer issues the PE(config-router-af)#neighbor 2.2.2.2 ttlsecurity hops 2 command. After issuing this command, which BGP packets does the PE accept?

A network engineer is configuring a router to send multicast traffic for the 239.10.10.10 group.

Which configuration must an .... forward the traffic?

Refer to the exhibit.

R101 is peering with R102 and R103, and R201 is peering with R202 and R203 using iBGP Labeled Unicast address families. The OSPF area 0 border routers are in a full iBGP Labeled Unicast mesh, and VPNv4 routes are exchanged directly between PE routers R101 and R201 through iBGP Which address family-level configuration must be applied on ABR R102 on ABR R102 to support a Unified MPLS routing architecture with partitioned IGP domains?

BGP has been implemented on a IOS XR router. Which configuration sends BGP IPv4 labels to build inter-domain LSPs?

Which module refers to the network automation using Ansible?

What is the characteristic of the Tl-LFA?