Cisco 300-410 Practice Test - Questions Answers, Page 55

Refer to the exhibit.

Refer to the exhibit R2 can reach Loopback222, but R1 SW1 and PC1 cannot communicate with 172.16.222 254 R1 and R2 configurations are shown here

Which EIGRP configuration command resolves the issue?

Refer to the exhibit.

Refer to the exhibit. An engineer configures router A to mark all inside to outside traffic from network 192 168 1 0, except from host 192 168 1 1. with critical IP precedence. The policy did not work as expected Which configuration resolves the issue?

A)

B)

C)

D)

Configuration on the hub router meets this requirement?

Refer to the exhibit.

Refer to the exhibit. A network engineer lost remote access to the router due to a network problem.

The engineer used the console to access the router and noticed continuous logs on the console terminal. Which configuration limits the number of log messages on the console to critical and higher seventy level messages?

Refer to the exhibit.

Refer to the exhibit The SNMP server with IP address 172.16 4 4 cannot access host router A Which configuration command on router A resolves the issue?

Refer to the exhibit.

Refer to the exhibit. An organization is installing a new L3 MPLS link to establish DM VPN Phase 2 tunnels between the hub and two spoke routers Which additional configuration should the engineer implement on each device to achieve optimal routing between the spokes?

A)

B)

C)

D)

Refer to the exhibit.

Refer to the exhibit Users from the 192 168.2.0/24 network cannot connect to the 172.16 2 32/28 network Which configuration resolves the issue'?

A)

B)

C)

D)

Refer to the exhibit.

Refer to the exhibit. A network engineer troubleshooting a packet drop problem for the host 172.16.100.5 notices that only one link is used and installed on the routing table, which saturates the bandwidth. Which action must the engineer take to resolve the high bandwidth utilization problem and share the traffic toward this host between the two available links?

Refer to the exhibit.

Refer to the exhibit. An engineer is troubleshooting a prefix advertisement issue from R3, which is not directly connected to R1. Which configuration resolves the issue?

A)

B)

C)

D)