Home / Cisco / 350-401

Cisco 350-401 Practice Test - Questions Answers, Page 12

Question list

List of questions

Question 111

(0)

An engineer measures the Wi-Fi coverage at a customer site. The RSSI values are recorded as follows: Which two statements does the engineer use to explain these values to the customer? (Choose tw

Question 112

(0)

Refer to the exhibit. Which set of commands on router r R1 Allow deterministic translation of private hosts PC1, PC2, and PC3 to addresses in the public space?

Question 113

(0)

What is a characteristic of YANG?

Question 114

(0)

Which two components are supported by LISP? (Choose two.)

Question 115

(0)

After a redundant route processor failure occurs on a Layer 3 device, which mechanism allows for packets to be forwarded from a neighboring router based on the most recent tables?

Question 116

(0)

Under which network conditions is an outbound QoS policy that is applied on a router WAN interface most beneficial?

Question 117

(0)

What is one difference between saltstack and ansible?

Question 118

(0)

A network administrator has designed a network with two multilayer switches on the distribution layer, which act as default gateways for the end hosts. Which two technologies allow every end host in

Question 119

(0)

Refer to the exhibit. An engineer attempts to configure a trunk between switch sw1 and switch SW2 using DTP, but the trunk does not form. Which command should the engineer apply to switch SW2 to r

Question 120

(0)

In cisco SD_WAN, which protocol is used to measure link quality?

Related questions

What are two differences between the RIB and the FIB? (Choose two.)

Which option works with a DHCP server to return at least one WLAN management interface IP address during the discovery phase and is dependent upon the VCI of the AP?

An engineer is troubleshooting the Ap join process using DNS. Which FQDN must be resolvable on the network for the access points to successfully register to the WLC?

An engineer must update the local web authentication details on a Cisco 5520 WLC. The engineer has one active SSID configured for web authentication and plans to update the virtual interface with a nonroutable IP address. Which command must the engineer apply?

Which port is required to allow APs to join a WLC when directed broadcasts are used on a Cisco iOS switch?

Refer to the exhibit. An engineer must allow R1 to advertise the 192 168.1 0/24 network to R2 R1 must perform this action without sending OSPF packets to SW1 Which command set should be applied?

Refer to the Exhibit. Refer to the exhibit. Which action must be performed to allow RESTCONF access to the device?

Reter to the exhibit. Refer to the exhibit. A network engineer must be notified when a user switches to configuration mode. Which script should be applied to receive an SNMP trap and a critical-level log message?

Refer to the Exhibit. Refer to the exhibit An engineer is troubleshooting an mDNS issue in an environment where Cisco ISE is used to dynamically assign mDNS roles to users The engineer has confirmed that ISE is sending the correct values, but name resolution is not functioning as expected Which WLC configuration change resolves the issue?

A company has an existing Cisco 5520 HA cluster using SSO. An engineer deploys a new single Cisco Catalyst 9800 WLC to test new features. The engineer successfully configures a mobility tunnel between the 5520 cluster and 9800 WLC. Client connected to the corporate WLAN roam seamlessly between access points on the 5520 and 9800 WLC. After a failure on the primary 5520 WLC, all WLAN services remain functional; however, Client roam between the 5520 and 9800 controllers without dropping their connection. Which feature must be configured to remedy the issue?

Question 111

An engineer measures the Wi-Fi coverage at a customer site. The RSSI values are recorded as follows:

Which two statements does the engineer use to explain these values to the customer? (Choose two)

The signal strength at location C is too weak to support web surfing

Location D has the strongest RF signal strength

The RF signal strength at location B is 50% weaker than location A

The signal strength at location B is 10 dB better than location C

The RF signal strength at location C is 10 times stronger than location B

Show Answer Comment (0)

Question 112

Refer to the exhibit. Which set of commands on router r R1 Allow deterministic translation of private hosts PC1, PC2, and PC3 to addresses in the public space?

Show Answer Comment (0)

Question 113

What is a characteristic of YANG?

It is a Cisco proprietary language that models NETCONF data

It allows model developers to create custom data types

It structures data in an object-oriented fashion to promote model reuse

It provides loops and conditionals to control now within models

Show Answer Comment (0)

Question 114

Which two components are supported by LISP? (Choose two.)

Proxy ETR

egress tunnel router

route reflector

HMAC algorithm

spoke

Show Answer Comment (0)

Question 115

After a redundant route processor failure occurs on a Layer 3 device, which mechanism allows for packets to be forwarded from a neighboring router based on the most recent tables?

BFD

RPVST+

RP failover

NSF

Show Answer Comment (0)

Question 116

Under which network conditions is an outbound QoS policy that is applied on a router WAN interface most beneficial?

under interface saturation condition

under network convergence condition

under all network condition

under traffic classification and marking conditions.

Show Answer Comment (0)

Question 117

What is one difference between saltstack and ansible?

SaltStack uses an API proxy agent to program Cisco boxes on agent mode, whereas Ansible uses a Telnet connection

SaltStack uses the Ansible agent on the box, whereas Ansible uses a Telnet server on the box

SaltStack is constructed with minion, whereas Ansible is constructed with YAML

SaltStack uses SSH to interact with Cisco devices, whereas Ansible uses an event bus

Show Answer Comment (0)

A network administrator has designed a network with two multilayer switches on the distribution layer, which act as default gateways for the end hosts. Which two technologies allow every end host in a VLAN to use both gateways? (Choose two)

GLBP

HSRP

MHSRP

VSS

VRRP

Show Answer Comment (0)

Question 119

Refer to the exhibit. An engineer attempts to configure a trunk between switch sw1 and switch SW2 using DTP, but the trunk does not form. Which command should the engineer apply to switch SW2 to resolve this issue?

switchport mode dynamic desirable

switchport nonegotiate

no switchport

switchport mode access

Show Answer Comment (0)