Cisco 350-401 Practice Test - Questions Answers, Page 13
Question list
List of questions
Related questions
Refer to the exhibit. An engineer configures a new HSRP group. While reviewing the HSRP status, the engineer sees the logging message generated on R2. Which is the cause of the message?
The same virtual IP address has been configured for two HSRP groups
The HSRP configuration has caused a spanning-tree loop
The HSRP configuration has caused a routing loop
A PC is on the network using the IP address 10.10.1.1
Which measure is used by an NTP server to indicate its closeness to the authoritative time source?
latency
hop count
time zone
stratum
What is the output of this code?
username Cisco
get_credentials
username
CISCO
An engineer runs the code against an API of Cisco DMA Center, and the platform returns this output What does the response indicate?
The authentication credentials are incorrect
The URl string is incorrect.
The Cisco DNA Center API port is incorrect
The HTTP method is incorrect
Refer to the exhibit. Which configuration must be applied to R to enable R to reach the server at 172.16.0.1?
Refer to the exhibit. An engineer has configured Cisco ISE to assign VLANs to clients based on their method of authentication, but this is not working as expected. Which action will resolve this issue?
require a DHCP address assignment
utilize RADIUS profiling
set a NAC state
enable AAA override
While configuring an IOS router for HSRP with a virtual IP of 10 1.1.1. an engineer sees this log message.
Which configuration change must the engineer make?
Change the HSRP group configuration on the local router to 1.
Change the HSRP virtual address on the local router to 10.1.1.1.
Change the HSRP virtual address on the remote router to 10.1.1.1.
Change the HSRP group configuration on the remote router to 1.
What is the function of a fabric border node in a Cisco SD-Access environment?
To collect traffic flow information toward external networks
To connect the Cisco SD-Access fabric to another fabric or external Layer 3 networks
To attach and register clients to the fabric
To handle an ordered list of IP addresses and locations for endpoints in the fabric.
A network engineer configures BGP between R1 and R2. Both routers use BGP peer group CORP and are set up to use MD5 authentication. This message is logged to the console of router R1:
“May 5 39:85:55.469: %TCP-6-BADAUTH” Invalid MD5 digest from 10.10.10.1 (29832) to 10.120.10.1 (179) tebleid -0
Which two configuration allow peering session to from between R1 and R2? Choose two.)
R1(config-router)#neighbor 10.10.10.1 peer-group CORP R1(config-router)#neighbor CORP password Cisco
R2(config-router)#neighbor 10.120.10.1 peer-group CORP R2(config-router)#neighbor CORP password Cisco
R2(config-router)#neighbor 10.10.10.1 peer-group CORP R2(config-router)#neighbor PEER password Cisco
R1(config-router)#neighbor 10.120.10.1 peer-group CORP R1(config-router)#neighbor CORP password Cisco
R2(config-router)#neighbor 10.10.10.1 peer-group CORP R2(config-router)#neighbor CORP password Cisco
Which two operational models enable an AP to scan one or more wireless channels for rouge access points and at the same time provide wireless services to clients? (Choose two.)
Rouge detector
Sniffer
FlexConnect
Local
Monitor
Question