Home

Home / Cisco / 350-401

Cisco 350-401 Practice Test - Questions Answers, Page 97

Question list

List of questions

Question 961

(0)

Question 962

(0)

Question 963

(0)

Question 964

(0)

Question 965

(0)

Question 966

(0)

Question 967

(0)

Question 968

(0)

Question 969

(0)

Question 970

(0)

Open VPLUS File

Convert VPLUS to PDF

Related questions

What are two differences between the RIB and the FIB? (Choose two.)

Which option works with a DHCP server to return at least one WLAN management interface IP address during the discovery phase and is dependent upon the VCI of the AP?

An engineer must update the local web authentication details on a Cisco 5520 WLC. The engineer has one active SSID configured for web authentication and plans to update the virtual interface with a nonroutable IP address. Which command must the engineer apply?

An engineer is troubleshooting the Ap join process using DNS. Which FQDN must be resolvable on the network for the access points to successfully register to the WLC?

Which port is required to allow APs to join a WLC when directed broadcasts are used on a Cisco iOS switch?

Refer to the Exhibit. Refer to the exhibit. Which action must be performed to allow RESTCONF access to the device?

Refer to the exhibit. An engineer must allow R1 to advertise the 192 168.1 0/24 network to R2 R1 must perform this action without sending OSPF packets to SW1 Which command set should be applied?

Refer to the Exhibit. Refer to the exhibit An engineer is troubleshooting an mDNS issue in an environment where Cisco ISE is used to dynamically assign mDNS roles to users The engineer has confirmed that ISE is sending the correct values, but name resolution is not functioning as expected Which WLC configuration change resolves the issue?

A company has an existing Cisco 5520 HA cluster using SSO. An engineer deploys a new single Cisco Catalyst 9800 WLC to test new features. The engineer successfully configures a mobility tunnel between the 5520 cluster and 9800 WLC. Client connected to the corporate WLAN roam seamlessly between access points on the 5520 and 9800 WLC. After a failure on the primary 5520 WLC, all WLAN services remain functional; however, Client roam between the 5520 and 9800 controllers without dropping their connection. Which feature must be configured to remedy the issue?

Which configuration allows administrators to configure the device through the console port and use a network authentication server? A) B) C) D)

Question 961

Report

SIMULATION

A.

See the solution below in Explanation

Show Answer Comment (0)

Question 962

Report

SIMULATION

A.

See the solution below in Explanation

Show Answer Comment (0)

Question 963

Report

SIMULATION

A.

See the solution below in Explanation

Show Answer Comment (0)

Question 964

Report

SIMULATION

A.

See the solution below in Explanation

Show Answer Comment (0)

Question 965

Report

SIMULATION

A.

See the solution below in Explanation

Show Answer Comment (0)

Question 966

Report

SIMULATION

OR

A.

See the solution below in Explanation

Show Answer Comment (0)

Question 967

Report

SIMULATION

A.

See the solution below in Explanation

Show Answer Comment (0)

Question 968

Report

SIMULATION

A.

See the solution below in Explanation

Show Answer Comment (0)

Question 969

Report

SIMULATION

A.

See the solution below in Explanation

Show Answer Comment (0)

Question 970

Report

SIMULATION

A.

See the solution below in Explanation

Show Answer Comment (0)

Total 983 questions

First

Prev

Last

Go to page: of 99