Home

Home / Cisco / 350-401

Cisco 350-401 Practice Test - Questions Answers, Page 98

Question list

List of questions

Question 971

(0)

Question 972

(0)

Question 973

(0)

SIMULATION OR OR OR

Question 974

(0)

Question 975

(0)

Question 976

(0)

Question 977

(0)

Question 978

(0)

Question 979

(0)

Question 980

(0)

Open VPLUS File

Convert VPLUS to PDF

Related questions

What are two differences between the RIB and the FIB? (Choose two.)

Which option works with a DHCP server to return at least one WLAN management interface IP address during the discovery phase and is dependent upon the VCI of the AP?

An engineer must update the local web authentication details on a Cisco 5520 WLC. The engineer has one active SSID configured for web authentication and plans to update the virtual interface with a nonroutable IP address. Which command must the engineer apply?

An engineer is troubleshooting the Ap join process using DNS. Which FQDN must be resolvable on the network for the access points to successfully register to the WLC?

Which port is required to allow APs to join a WLC when directed broadcasts are used on a Cisco iOS switch?

Refer to the Exhibit. Refer to the exhibit. Which action must be performed to allow RESTCONF access to the device?

Refer to the exhibit. An engineer must allow R1 to advertise the 192 168.1 0/24 network to R2 R1 must perform this action without sending OSPF packets to SW1 Which command set should be applied?

Refer to the Exhibit. Refer to the exhibit An engineer is troubleshooting an mDNS issue in an environment where Cisco ISE is used to dynamically assign mDNS roles to users The engineer has confirmed that ISE is sending the correct values, but name resolution is not functioning as expected Which WLC configuration change resolves the issue?

A company has an existing Cisco 5520 HA cluster using SSO. An engineer deploys a new single Cisco Catalyst 9800 WLC to test new features. The engineer successfully configures a mobility tunnel between the 5520 cluster and 9800 WLC. Client connected to the corporate WLAN roam seamlessly between access points on the 5520 and 9800 WLC. After a failure on the primary 5520 WLC, all WLAN services remain functional; however, Client roam between the 5520 and 9800 controllers without dropping their connection. Which feature must be configured to remedy the issue?

Which configuration allows administrators to configure the device through the console port and use a network authentication server? A) B) C) D)

Question 971

Report

SIMULATION

A.

See the solution below in Explanation

Show Answer Comment (0)

Question 972

Report

SIMULATION

A.

See the solution below in Explanation

Show Answer Comment (0)

Question 973

Report

SIMULATION

OR

OR

OR

A.

See the solution below in Explanation

Show Answer Comment (0)

Question 974

Report

SIMULATION

A.

See the solution below in Explanation

Show Answer Comment (0)

Question 975

Report

SIMULATION

A.

See the solution below in Explanation

Show Answer Comment (0)

Question 976

Report

SIMULATION

A.

See the solution below in Explanation

Show Answer Comment (0)

Question 977

Report

SIMULATION

A.

See the solution below in Explanation

Show Answer Comment (0)

Question 978

Report

SIMULATION

A.

See the solution below in Explanation

Show Answer Comment (0)

Question 979

Report

SIMULATION

A.

See the solution below in Explanation

Show Answer Comment (0)

Question 980

Report

SIMULATION

A.

See the solution below in Explanation

Show Answer Comment (0)

Total 983 questions

First

Prev

Go to page: of 99