Cisco 300-410 Practice Test - Questions Answers, Page 10
Question list
List of questions
Related questions
Which SNMP verification command shows the encryption and authentication protocols that are used in SNMPV3?
show snmp group
show snmp user
show snmp
show snmp view
Which is statement about IPv6 inspection is true?
It teams and secures bindings for stateless autoconfiguration addresses in Layer 3 neighbor tables
It learns and secures bindings for stateful autoconfiguration addresses in Layer 3 neighbor tables
It teams and secures bindings for stateful autoconfiguration addresses in Layer 2 neighbor tables
It team and secures binding for stateless autoconfiguration addresses in Layer 2 neighbor tables.
What is the output of the following command: show ip vrf ?
Show's default RD values
Displays IP routing table information associated with a VRF
Show's routing protocol information associated with a VRF.
Displays the ARP table (static and dynamic entries) in the specified VRF
Refer to the exhibit.
The server for the finance department is not reachable consistently on the 200.30.40.0/24 network and after every second month it gets a new IP address. Which two actions must be taken to resolve this Issue? (Choose two.)
Configure the server to use DHCP on the network with default gateway 200 30.40.100.
Configure the server with a static IP address and default gateway.
Configure the router to exclude a server IP address.
Configure the server to use DHCP on the network with default gateway 200 30.30.100.
Configure the router to exclude a server IP address and default gateway.
Refer to the exhibit.
An engineer has configured DMVPN on a spoke router. What is the WAN IP address of another spoke router within the DMVPN network?
172.18.46.2
192.168.1.4
172.18.16.2
192.168.1.1
An engineer is configuring a network and needs packets to be forwarded to an interface for any destination address that is not in the routing table. What should be configured to accomplish this task?
set ip next-hop
set ip default next-hop
set ip next-hop recursive
set ip next-hop verify-availability
Which protocol does MPLS use to support traffic engineering?
Tag Distribution Protocol (TDP)
Resource Reservation Protocol (RSVP)
Border Gateway Protocol (BGP)
Label Distribution Protocol (LDP)
Refer to the exhibit.
A network engineer for AS64512 must remove the inbound and outbound traffic from link A during maintenance without closing the BGP session so that there ............ a backup link over link A toward the ASN. Which BGP configuration on
R1 accomplishes this goal?
Refer to the exhibit.
R1 is being monitored using SNMP and monitoring devices are getting only partial information. What action should be taken to resolve this issue?
Modify the CoPP policy to increase the configured exceeded limit for SNMP.
Modify the access list to include snmptrap.
Modify the CoPP policy to increase the configured CIR limit for SNMP.
Modify the access list to add a second line to allow udp any any eq snmp
Refer to the exhibit.
To provide reachability to network 10.1.1.0 /24 from R5, the network administrator redistributes EIGRP into OSPF on R3 but notices that R4 is now taking a ........... path through R5 to reach 10.1.1.0/24 network. Which action fixes the issue while keeping the reachability from R5 to 10.1.1.0/24 network?
Change the administrative distance of the external EIGRP to 90.
Apply the outbound distribution list on R5 toward R4 in OSPF.
Change the administrative distance of OSPF to 200 on R5.
Redistribute OSPF into EIGRP on R4
Question