Cisco 350-401 Practice Test - Questions Answers, Page 59
Question list
List of questions
Related questions
Refer to the exhibit.
Refer to the exhibit. Which command allows hosts that are connected to FastEthernet0/2 to access the Internet?
ip nat inside source list 10 interface FastEthernet0/1 overload
ip nat inside source list 10 interface FastEthernet0/2 overload
ip nat outside source list 10 interface FastEthernet0/2 overload
ip nat outside source static 209.165.200.225 10.10.10.0 overload
Which A record type should be configured for access points to resolve the IP address of a wireless LAN controller using DNS?
CISCO.CONTROLLER.localdomain
CISCO.CAPWAP.CONTROLLER.localdomain
CISCO-CONTROLLER.localdomain
CISCO-CAPWAP-CONTROLLER.localdomain
By default, which virtual MAC address does HSRP group 30 use?
00:05:0c:07:ac:30
00:00:0c:07:ac:1e
05:0c:5e:ac:07:30
00:42:18:14:05:1e
Which activity requires access to Cisco DNA Center CLI?
provisioning a wireless LAN controller
creating a configuration template
upgrading the Cisco DNA Center software
graceful shutdown of Cisco DNA Center
Which NTP mode must be activated when using a Cisco router as an NTP authoritative server?
primary
server
broadcast client
peer
Refer to the exhibit.
Refer to the exhibit. An engineer must configure an ERSPAN tunnel that mirrors traffic from linux1 on Switch1 to Linux2 on Switch2. Which command must be added to the destination configuration to enable the ERSPAN tunnel?
(config-mon-erspan-dst-src)# origin ip address 172.16.10.10
(config-mon-erspan-dst-src)# erspan-id 172.16.10.10
(config-mon-erspan-dst-src)# no shut
(config-mon-erspan-dst-src)# erspan-id 110
An engineer is configuring RADIUS-Based Authentication with EAP. MS-CHAPv2 is configured on a client device. Which outer method protocol must be configured on the ISE to support this authentication type?
EAP-TLS
EAP-FAST
LDAP
PEAP
What are two characteristics of Cisco SD-Access elements? (Choose two.)
The border node is required for communication between fabric and nonfabric devices.
Traffic within the fabric always goes through the control plane node.
Fabric endpoints are connected directly to the border node.
The control plane node has the full RLOC-to-EID mapping database.
The border node has the full RLOC-to-EID mapping database.
An engineer is connected to a Cisco router through a Telnet session. Which command must be issued to view the logging messages from the current session as soon as they are generated by the router?
logging buffer
service timestamps log uptime
logging host
terminal monitor
SIMULATION
BGP connectivity exists between Headquarters and both remote sites; however, Remote Site 1 cannot communicate with Remote Site 2. Configure BGP according to the topology to goals:
Configure R1 and R3 under the BGP process to provide reachability between Remote Site 1 and Remote Site 2. No configuration changes are permitted on R2.
Ensure that the /32 networks at Remote Site 1 and Remote Site 2 can ping each other.
R1
R3
See the solution below in
Question