Cisco 300-410 Practice Test - Questions Answers, Page 20
List of questions
Question 191
Refer to the exhibit.
When monitoring an IPv6 access list, an engineer notices that the ACL does not have any hits and is causing unnecessary traffic to pass through the interface Which command must be configured to resolve the issue?
Question 192
Refer to the exhibit.
The network administrator configured redistribution on an ASBR to reach to all WAN networks but failed Which action resolves the issue?
Question 193
How does an MPLS Layer 3 VPN function?
Question 194
Refer to the exhibit.
Which action resolves the failed authentication attempt to the router?
Question 195
A customer reports to the support desk that they cannot print from their PC to the local printer id:401987778. Which tool must be used to diagnose the issue using Cisco DNA Center Assurance?
Question 196
When determining if a system is capable of support, what is the minimum time spacing required for a BFD control packet to receive once a control packet is arrived?
Question 197
Refer to the exhibit.
Troubleshoot and ensure that branch B only ever uses the MPLS B network to reach HQ. Which action achieves this requirement?
Question 198
Refer to the exhibit.
The OSPF routing protocol is redistributed into the BGP routing protocol, but not all the OSPF routes are distributed into BGP Which action resolves the issue?
Question 199
Refer to the exhibit.
PC-2 failed to establish a Telnet connection to the terminal server Which configuration resolves the issue?
Question 200
What statement about route distinguishes in an MPLS network is true?
Question