Cisco 300-410 Practice Test - Questions Answers, Page 23

List of questions
Question 221

Which mechanism must be chosen to optimize the reconvergence time for OSPF at company location 407173257 that is less CPU-intensive than reducing the hello and dead timers?
Question 222

A network administrator performed a Compact Flash Memory upgrade on a Cisco Catalyst 6509 Switch. Everything is functioning normally except SNMP, which was configured to monitor the bandwidth of key interfaces but the interface indexes are changed. Which global configuration resolves the issue?
Question 223

Refer to the exhibit.
Which two commands provide the administrator with the information needed to resolve the issue?
(Choose two.)
Question 224

Refer to the exhibit.
Which two commands provide the administrator with the information needed to resolve the issue?
(Choose two.)
Question 225

Refer to the exhibit. An engineer must establish multipoint GRE tunnels between hub router R6 and branch routers R1, R2, and R3. Which configuration accomplishes this task on R1?
Question 226

Refer to the exhibit.
Which set of commands restore reachability to loopback0?
Question 227

Refer to the exhibit.
An engineer configured SNMP communities on the Core_SW1, but the SNMP server cannot obtain information from Core_SW1. Which configuration resolves this issue?
Question 228

What is a characteristic of Layer 3 MPLS VPNs?
Question 229

Refer to the exhibit.
An engineer configured IP SLA on R1 to avoid the ISP link flapping problem. but it is not working as designed IP SLA should wait 30 seconds before switching traffic to a secondary connection and then revert to the primary link after waning 20 seconds, when the primary link is available and stabilized.
Which configuration resolves the issue?
Question 230

Refer to the exhibit.
A network administrator sets up an OSPF routing protocol for a DMVPN network on the hub router.
Which configuration required to establish a DMVPN tunnel with multiple spokes?
Question