ExamGecko
Login
Home / Cisco / 300-410 / List of questions
Ask Question

Cisco 300-410 Practice Test - Questions Answers, Page 32

Add to Whishlist

List of questions

Question 311

Report Export Collapse

Refer to the exhibit.

Cisco 300-410 image Question 311 111257 10072024005413000000

R1 is configured with IP SLA to check the availability of the server behind R6 but it kept failing. Which configuration resolves the issue?

Become a Premium Member for full access
  Unlock Premium Member

Question 312

Report Export Collapse

Refer to the exhibit.

Cisco 300-410 image Question 312 111258 10072024005413000000

A loop occurs between R1, R2, and R3 while EIGRP is run with poison reverse enabled. Which action prevents the loop between R1, R2, and R3?

Become a Premium Member for full access
  Unlock Premium Member

Question 313

Report Export Collapse

A customer reports that traffic is not passing on an EIGRP enabled multipoint interface on a router configured as below: interface Serial0/0 no ip address interface Server0/0/0.9 multipoint ip address 10.1.1.1 255.255.255.248 ip split-horizon eigrp 1 Which action resolves the issue?

Become a Premium Member for full access
  Unlock Premium Member

Question 314

Report Export Collapse

A newly installed spoke router is configured for DMVPN with the ip mtu 1400 command. Which configuration allows the spoke to use fragmentation with the maximum negotiated TCP MTU over GRE?

Become a Premium Member for full access
  Unlock Premium Member

Question 315

Report Export Collapse

What are the two goals of micro BFD sessions? (Choose two.)

Become a Premium Member for full access
  Unlock Premium Member

Question 316

Report Export Collapse

An engineer configured a router with this configuration ip access-hst DENY TELNET 10 deny tcp any any eq 23 log-input The router console starts receiving log message :%SEC-6-IPACCESSLOGP: list DENY_TELNET denied tcp

192.168.1.10(1022)(FastEthernet1/0 D508.89gb.003f) ->192.168.2.20(23), 1 packet" Which action stops messages on the console while still denying Telnet?

Become a Premium Member for full access
  Unlock Premium Member

Question 317

Report Export Collapse

Refer to the exhibit.

Cisco 300-410 image Question 317 111263 10072024005413000000

While troubleshooting a BGP route reflector configuration, an engineer notices that reflected routes are missing from neighboring routers. Which two BGP configurations are needed to resolve the issue? (Choose two)

Become a Premium Member for full access
  Unlock Premium Member

Question 318

Report Export Collapse

Which IPv6 first hop security feature controls the traffic necessary for proper discovery of neighbor device operation and performance?

Become a Premium Member for full access
  Unlock Premium Member

Question 319

Report Export Collapse

DRAG DROP

Drag and drop the OSPF adjacency states from the left onto the correct descriptions on the right.

Cisco 300-410 image Question 319 111265 10072024005413000000

Become a Premium Member for full access
  Unlock Premium Member

Question 320

Report Export Collapse

DRAG DROP

Drag and drop the MPLS terms from the left onto the correct definitions on the right.


Become a Premium Member for full access
  Unlock Premium Member
Total 592 questions
Go to page: of 60
Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Refer to the exhibit. Users in the branch network of 2001:db8:0:4::/64 report that they cannot access the Internet. Which command is issued in IPv6 router EIGRP 100 configuration mode to solve this issue?
Refer to the exhibit. The output of the trace route from R5 shows a loop in the network. Which configuration prevents this loop?
Which two labet distribution methods are used by routers in MPLS? (Choose two )
Refer to the exhibit. ISP 1 and ISP 2 directly connect to the Internet. A customer is tracking both ISP links to achieve redundancy and cannot see the Cisco IOS IP SLA tracking output on the router console. Which command is missing from the IP SLA configuration?
Refer to the exhibit. Refer to lhe exhibit After an engineer configured a new Cisco rouler as a DHCP server, users reponed iwo primary issues: Devices in the HR subnet have intermittent connectivity problems. Workstations in the LEGAL subnet cannot obtain IP addresses. Which configurations must the engineer apply to ROUTER_1 to restore connectivity for the affected devices?
R2 has a locally originated prefix 192.168.130.0/24 and has these configurations: What is the result when the route-map OUT command is applied toward an eBGP neighbor R1 (1.1.1.1) by using the neighbor 1.1.1.1 route-map OUT out command?
When provisioning a device in Cisco DNA Center, the engineer sees the error message "Cannot select the device. Not compatible with template". What is the reason for the error?
Refer to the exhibit. What is the result of applying this configuration?
Refer to the exhibit. Refer to the exhibit An engineer observes that every time the ICMP packet is lost at a polling interval, track 1 goes down, which causes unnecessary disruption and instability in the network. The engineer does not want the traffic to be rerouted if the loss of ICMP packets is negligible. If the packet loss is persistent for a longer duration, the track must go down and the traffic must be rerouted. Which action resolves the issue?
Refer to the exhibit. The network operation team observes a traffic forwarding issue between R2 and R3: Ping and traceroute of loopback IP address from R2 to R3 is successful. iBGP peering in AS 65101 and AS 65201 is up. Which configuration resolves the issue?