Cisco 300-410 Practice Test - Questions Answers, Page 34

DRAG DROP

Drag and Drop the IPv6 First-Hop Security features from the left onto the definitions on the right.

DRAG DROP

Drag and drop the MPLS concepts from the left onto the descriptions on the right.

Refer to the exhibit.

TCP traffic should be reaching host 10.10.10.10/24 via R2. Which action resolves the issue?

A network administrator must optimize the segment size of the TCP packet on the DMVPN IPsec protected tunnel interface, which carries application traffic from the head office to a designated branch. The TCP segment size must not overwhelm the MTU of the outbound link. Which configuration must be applied to the router to improve the application performance?

Refer to the exhibit.

After configuring OSPF in R1, some external destinations in the network became unreachable. Which action resolves the issue?

What is the function of BFD?

Refer to the exhibit.

A network engineer must establish communication between three different customer sites with these requirements:

Site-A: must be restricted to access to any users at Site-B or Site-C.

Site-B and Site-C must be able to communicate between sites and share routes using OSPF.

Which configuration meets the requirements?

Refer to the exhibit.

Refer to the exhibit. Site1 must perform unequal cost load balancing toward the segments behind Site2 and Site3. Some of the routes are getting load balanced but others are not. Which configuration allows Site1 to load balance toward all the LAN segments of the remote routers?

Refer to the exhibit.

Refer to the exhibit. An engineer implemented an access list on R1 to allow anyone to Telnet except R2 Loopback0 to R1 Loopback4 How must sequence 20 be replaced on the R1 access list to resolve the issue?