Cisco 300-410 Practice Test - Questions Answers, Page 35

List of questions
Question 341

An engineer notices that R1 does not hold enough log messages to Identity the root cause during troubleshooting Which command resolves this issue?
Option A
Option B
Option C
Option D
Question 342

Refer to the Exhibit.
R1 and R2 use IGP protocol to route traffic between AS 100 and AS 200 despite being configured to use BGP. Which action resolves the issue and ensures the use of BGP?
Question 343

Refer to the exhibit.
An engineer is trying to connect to R1 via Telnet with no success. Which configuration resolves the issue?
Question 344

Refer to the exhibit.
An engineer must configure PBR on R1 to reach to 10.2.2.0/24 via R3 AS64513 as the primary path and a backup route through default route via R2 AS64513. All BGP routes are in the routing table of R1. but a static default route overrides BGP routes. Which PBR configuration achieves the objective?
Question 345

Refer to the exhibit.
An administrator configured a Cisco router for TACACS authentication, but the router is using the local enable password instead Which action resolves the issue?
Question 346

Refer to the exhibit.
Refer to the exhibit. An engineer configured BGP and wants to select the path from 10.77.255.57 as the best path instead of current best path. Which action resolves the issue?
Question 347

What is LDP label binding?
Question 348

Which table is used to map the packets in an MPLS LSP that exit from the same interface, via the same next hop, and have the same queuing policies?
Question 349

Refer to the exhibit.
Refer to the exhibit. The IT router has been configured with the Science VRF and the interfaces have been assigned to the VRF Which set of configurations advertises Science-1 and Science-2 routes using EIGRPAS 111?
Question 350

Refer to the exhibit.
Refer to the exhibit. When an FTP client attempts to use passive FTP to connect to the FTP server, the file transfers fail Which action resolves the issue?
Question