Cisco 300-410 Practice Test - Questions Answers, Page 36
Question list
List of questions
Related questions
In a DMVPN network, the Spoke1 user observed that the voice traffic is coming to Spoke2 users via the hub router. Which command is required on both spoke routers to communicate directly to one another?
ip nhrp map dynamic
ip nhrp shortcut
ip nhrp nhs multicast
ip nhrp redirect
Refer to the exhibit.
The network administrator configured the network to establish connectivity between all devices and notices that the ASBRs do not have routes for each other. Which set of configurations resolves this issue?
Option A
Option B
Option C
Option D
Refer to the exhibit.
The network administrator configured the Chicago router to mutually redistribute the LA and NewYork routes with OSPF routes to be summarized as a single route in EIGRP using the longest summary mask:
After the configuration, the New York router receives all the specific LA routes but the summary route. Which set of configurations resolves the issue on the Chicago router?
Option A
Option B
Option C
Option D
Refer to the exhibit.
An engineer must configure DMVPN Phase 3 hub-and-spoke topology to enable a spoke-to-spoke tunnel. Which NHRP configuration meets the requirement on R6?
Option A
Option B
Option C
Option D
Refer to the exhibit.
An engineer implemented CoPP to limit Telnet traffic to protect the router CPU. It was noticed that the Telnet traffic did not pass through CoPP Which configuration resolves the issue?
Option A
Option B
Option C
Option D
Refer to the exhibit.
An engineer implemented CoPP but did not see OSPF traffic going through it. Which configuration resolves the issue?
Option A
Option B
Option C
Option D
An engineer must override the normal routing behavior of a router for Telnet traffic that is destined to 10.10.10.10 from 10.10.1.0/24 via a next hop of 10.4.4.4. which is directly connected to the router that is connected to the 10.1.1.0/24 subnet Which configuration reroutes traffic according to this requirement?
Option A
Option B
Option C
Option D
Refer to the exhibit.
An engineer must redistribute networks 192.168.10.0/24 and 192.168.20.0/24 into OSPF from EIGRP. where the metric must be added when traversing through multiple hops to start an external route of 20 The engineer notices that the external metric is fixed and does not add at each hop. Which configuration resolves the issue?
Option A
Option B
Option C
Option D
An administrator attempts to download the pack NBAR2 file using TFTP from the CPE router to another device over the Gi0/0 interface. The CPE is configured as below:
The transfer fails. Which action resolves the issue?
Change the WAN ACL to permit the UDP port 69 to allow TFTP
Make the permit udp any eq tftp any entry the last entry in the WAN ACL.
Change the WAN ACL to permit the entire UDP destination port range
Shorten the file name to the 8+3 naming convention.
What is an MPLS LDP targeted session?
session between neighbors that are connected no more than one hop away
LDP session established between LSRs by exchanging TCP hello packets
label distribution session between non-directly connected neighbors
LDP session established by exchanging multicast hello packets
Question