Cisco 300-410 Practice Test - Questions Answers, Page 42
List of questions
Question 411
The network administrator must implement IPv6 in the network to allow only devices that not only have registered IP addresses but are also connecting from assigned locations. Which security feature must be implemented?
Question 412
What must be configured by the network engineer to circumvent AS_PATH prevention mechanism in IP/VPN Hub and Spoke deployment scenarios?
Question 413
A network engineer must configure a DMVPN network so that a spoke establishes a direct path to another spoke if the two must send traffic to each other. A spoke must send traffic directly to the hub if required. Which configuration meets this requirement?
Question 414
Refer to the exhibit.
R3 cannot authenticate via TACACS. Which configuration resolves the issue?
Question 415
Refer to the exhibit.
An administrator must configure the router with OSPF for IPv4 and IPv6 networks under a single process. The OSPF adjacencies are not established and did not meet the requirement. Which action resolves the issue?
Question 416
The summary route is not shown in the Router_B routing table after this below configuration on Router_A:
Which Router_A configuration resolves the issue by advertising the summary route to Route_B?
Question 417
How do devices operate in MPLS L3VPN topology?
Question 418
Refer to the exhibit.
An administrator is attempting to disable the automatic logout after a period of inactivity. After logging out the console stopped responding to all keyword inputs. Remote access through SSH still work resolves the issue?
Question 419
Refer to the exhibit.
A NOC team receives a ticket that data traffic from RA to RF is not forwarded when the link between the RC-RE path goes down. All routers learn loopback IP through the IGP protocol. Which configuration resolves?
Question 420
Which feature is used by LDP in the forwarding path within the MPLS cloud?
Question