Cisco 300-410 Practice Test - Questions Answers, Page 44
Question list
List of questions
Related questions
Refer to the exhibit.
An engineer configured NetFlow to capture traffic information through the router, but it iOS not working as expected. Which action captures the flow information from this router to the collector?
Change the interface configuration FLOW-MONITOR-1 from input to output.
Configure a flow exporter under flow FLOW-MONITOR-1.
Configure more than one flow exporter destination addresses.
Change the flow exporter transport protocol from UDP to TCP
Refer to the exhibit.
After the network administrator rebuilds the IPv6 DHCP server, clients are not getting the IPv6 address lease. Which action resolves the issue?
Remove FE80 A8BB CCFF FEOO 5000 assigned by the IPV6 DHCP server.
Add Ipv6 dhcp sarver MY_POOL under the interface ethernet 0/0 on H1.
Add Ipv6 dhcp server MY_POOL under the interface ethernet 0/0 on R1.
Configure FF02::1:2 to discover al IPv6 OHCP cfcents
Refer to the exhibit.
A network administrator must configure DMVPN tunnels between the hub and spoke with dynamic spoke-to-spoke tunnel capabilities using EIGRP. Which tunnel interface command must the network administrator configure to establish an
EIGRP peer?
no ip next-hop-self eigrp 1
ip next-hop-self eigrp 1
no Ip nhrp ntxt-hop-self
ip nhrp next-hop-self
Refer to the exhibit.
Refer to the exhibit. Not all connected and static routes of router B are received by router A even though EIGRP neighborship is established between the routers. Which configuration resolves the issue?
Which router attaches the VPN label to incoming packets from CE routing?
CE router
core router
P router
PE router
Refer to the exhibit.
An error message "an OSPF-4-FLOOD_WARî is received on SW2 from SW1. SW2 is repeatedly receiving its own link-state advertisement and flushes it from the network. Which action resolves the issue?
Change area 5 to a normal area from a nonstub area
Resolve different subnet mask issue on the link
Configure Layer 3 port channel on interfaces between switches
Resolve duplicate IP address issue in the network
Refer to the exhibit.
An engineer must configure EIGRP between R1 and R2 with no summary route. Which configuration resolves the issue?
Refer to the exhibit.
The connected routers do not show up as OSPF neighbors. Which action resolves the issue?
Change the R1 dead timer to 20.
Change the R2 dead timer to 20.
Change the R2 hello timer to 20.
Change the R1 hello timer to 20.
Refer to the exhibit.
The forwarding entries how that the next hop for prefixes from the 172.16.0.0/16 network is set to 10.2.2.2 instead of 10.1.1.1. Which action resolves the issue?
Add set ip next hop 10.1.1.1 in route-map RED permit 20.
Add the continue statement in route-map RED permit 10 instead of continue 20.
Remove match ip address prefix-list 1 from route-map RED permit 10.
Remove the continue 20 statement from route-map RED permit 10
Refer to the exhibit.
Refer to the exhibit. The default route is not advertised to the neighboring router. Which action resolves the issue?
Configure the redistribute static metric 200 subnets command under OSPF.
Configure OSPF on the Dialer0 interface.
Configure the network 0.0.0.0 255.255.255.255 area 0 command under OSPF.
Configure the default-information originate command under OSPF.
Question