Cisco 300-410 Practice Test - Questions Answers, Page 46
Question list
List of questions
Related questions
Refer to the exhibit.
Refer to the exhibit. An engineer noticed that the router log messages do not have any information about when the event occurred. Which action should the engineer take when enabling service time stamps to improve the logging functionality at a granular level?
Configure the debug uptime option
Configure the msec option
Configure the timezone option
Configure the tog uptime option
Refer to the exhibit.
An engineer noticed that the router log messages do not have any information about when the event occurred. Which action should the engineer take when enabling service time stamps to improve the logging functionality at a granular level?
Replace OSPF process 10 on the interfaces with OSPF process 1 and configure an additional router IO with IPv6 address
Replace OSPF process 10 on the interfaces with OSPF process 1. and remove process 10 from the global configuration
Replace OSPF process 10 on the interfaces with OSPF process 1 for the IPv6 address and remove process 10 from the global configuration
Replace OSPF process 10 on the interfaces with OSPF process 1 for the IPv4 address and remove process 10 from the global configuration
How is a preshared key "Testíí for all the remote VPN rooters configured In a DMVPN using GRE over IPsec set up?
authentication pre-share Test address 0.0.0.0 0.0.0.0
set pre-share Test address 0.0.0.0 0.0.0.0
crypto Ipsec key Test address 0.0.0.0 0.0.0.0
crypto isakmp key Test address 0.0.0.0 0.0.0.0
Refer to the exhibit.
An engineer configures two ASBRs 10 4 17.6 and 10 4 15 5 in an OSPF network to redistribute routes from EIGRP However, both ASBRs show the EIGRP routes as equal costs even though the next-hop router 10 4 17 6 is closer to R1
How should the network traffic to the EIGRP prefixes be sent via 10 4.17.6?
The administrative distance should be raised to 120 from the ASBR 10.4.15 5.
The redistributed prefixes should be advertised as Type 1
The ASBR 10 4 17 6 should assign a tag to match and assign a lower metnc on R1
The administrative distance should be raised to 120 from the ASBR 104.17.6
The admitstrative distance should be raised to 120 from the ASBR 104 15.5.
The redistributed prefixes should be advertised as Type 1.
The ASBR 10 4 17 6 should assign a tag to match and assign a tower metnc on R1
The administrative distance should be raised to 120 from the ASBR 104 17 6
An engineer configured routing between multiple OSPF domains and introduced a routing loop that caused network instability. Which action resolves the problem?
Set a tag using the redistribute command toward a domain and deny inbound m the other domain by a matching tag
Set a tag using the redistribute command toward a different domain and deny the matching tag when exiting from that domain
Set a tag using the network command in a domain and use the route-map command to deny the matching lag when exiting toward a different domain
Set a tag using the network command in a domain and use the route-map command to deny the matching tag when entering into a different domain
Refer to the exhibit.
The Customer Edge router (AS 65500) wants to use ASC100 as the preferred ISP for all external routes.
This configuration failed to send routes to AS 100 as the preferred path. Which set of configuration resolves the issue?
Option A
Option B
Option C
Option D
Refer to the exhibit.
Refer to the exhibit.
A shoe retail company implemented the uRPF solution for an antispoofing attack. A network engineer received the call that the branch A server is under an IP spoofing attack. Which configuration must be implemented to resolve the attack?
Refer to the exhibit.
Refer to the exhibit. A network engineer is troubleshooting a failed link between R2 and R3 No traffic loss is reported from router R5 to HQ Which command fixes the separated backbone?
R2(config-router)#no area 21 stub
R2(config_router)#area 21 virtual-link 192.168.125.5
R3(config-router)#area 21 virtual-link 192.168.125.5
R3(config-router)#no area 21 stub
Refer to the exhibit.
Refer to the exhibit. An administrator must harden a router, but the administrator failed to test the SSH access successfully to the router. Which action resolves the issue?
Configure SSH on the remote device to log m using SSH
SSH syntax must be ssh -I user ip to log in to the remote device
Configure enable secret to log in to the device
SSH must be allowed with the transport output ssh command
Refer to the exhibit.
An engineer must configure OSPF with R9 and R10 and configure redistribution between OSPF and RIP causing a routing loop Which configuration on R9 and R10 meets this objective?
Question