In a cloud-computing environment what is rapid elasticity?

automatic adjustment of capacity based on need

control and monitoring of resource consumption by the tenant

automatic adjustment of capacity based on need

pooling resources in a multitenant model based on need

self-service of computing resources by the tenant

What is a reason to implement IPv4 private addressing?

Reduce the size of the forwarding table on network routers

Reduce the risk of a network security breach

Reduce the size of the forwarding table on network routers

What is the purpose of configuring different levels of syslog for different devices on the network?

to set the severity of syslog messages from each device

to rate-limit messages for different seventy levels from each device

to set the severity of syslog messages from each device

to identify the source from which each syslog message originated

to control the number of syslog messages from different devices that are stored locally

What is a function of MAC address learning?

It is enabled by default on all VLANs and interfaces

It increases the potential for MAC address flooding.

It is disabled by default on all interfaces connected to trunks

lt increases security on the management VLAN

Which two IPv6 addresses are used to provide connectivity between two routers on a shared link?(Choose two)

;jff06bb43cd4dd111bbff02 4545234d

What are two features of the DHCP relay agent? (Choose two.)

permits one IP helper command under an individual Layer 3 interface

configured under the Layer 3 interface of a router on the client subnet

assigns DNS locally and then forwards request to DHCP server

permits one IP helper command under an individual Layer 3 interface

allows only MAC-to-IP reservations to determine the local subnet of a client

minimizes the necessary number of DHCP servers

configured under the Layer 3 interface of a router on the client subnet

Which is a fact related to FTP?

It uses two separate connections for control and data traffic

It uses block numbers to identify and mitigate data-transfer errors

It always operates without user authentication

It relies on the well-known UDP port 69.

It uses two separate connections for control and data traffic

Which enhancement is implemented in WPA3?

protects against brute force attacks

employs PKI to identify access points

protects against brute force attacks

What must be considered for a locally switched FlexConnect AP if the VLANs that are used by the AP and client access are different?

The native VLAN must match the management VLAN of the AP

The APs must be connected to the switch with multiple links in LAG mode

The switch port mode must be set to trunk

The native VLAN must match the management VLAN of the AP

IEEE 802.10 trunking must be disabled on the switch port.

What is an advantage of using auto mode versus static mode for power allocation when an access point is connected to a PoE switch port?

Power policing is enabled at the same time

All four pairs of the cable are used

It detects the device is a powered device

The default level is used for the access point

Power policing is enabled at the same time

What is a function of an endpoint?

It is used directly by an individual user to access network services

It passes unicast communication between hosts in a network

It transmits broadcast traffic between devices in the same VLAN

It provides security between trusted and untrusted sections of the network.

Refer to the exhibit. Wireless LAN access must be set up to force all clients from the NA WLAN to authenticate against the local database. The WLAN is configured for local EAP authentication. The time that users access the network must not be limited.Which action completes this configuration?

Set the Lifetime (seconds) value to 0

Uncheck the Guest User check box

Check the Guest User Role check box

Set the Lifetime (seconds) value to 0

Clear the Lifetime (seconds) value

Refer to the exhibit. What is the next step to complete the implementation for the partial NAT configuration shown?

Reconfigure the static NAT entries that overlap the NAT pool

Configure the NAT outside interface

Modify the access list for the internal network on e0/1

Apply the ACL to the pool configuration

What are two reasons a switch experiences frame flooding? (Choose two.)

A defective patch cable is connected to the switch port

Topology changes are occurring within spanning-tree

A defective patch cable is connected to the switch port

Topology changes are occurring within spanning-tree

An aged MAC (able entry is causing excessive updates

Port-security is configured globally

The forwarding table has overflowed

Refer to the exhibit. A network engineer must configure router R1 with a host route to the server. Which command must the engineer configure?

R1(Config)#lp route 10.10.10.10 265.255.255.255 192 168.0.2

R1(conftg)#lp route 10.10.10.0 255.255.255.0 192.168.0.2

R1(Config)#lp route 10.10.10.10 265.255.255.255 192 168.0.2

R1(config)#ip route 192.168.0.2 255.255.255.255 10.10.10.10

R1(config)3|p route 0.0.0.0 0.0 0.0 192 168.0.2

A Cisco engineer at a new branch office is configuring a wireless network with access points that connect to a controller that is based at corporate headquarters Wireless client traffic must terminate at the branch office and access-point survivability is required in the event of a WAN outage Which access point mode must be selected?

OfficeExtend with high availability disabled

Lightweight with local switching disabled

OfficeExtend with high availability disabled

FlexConnect with local switching enabled

Refer to Itie exhibit A network engineer started to configure port security on a new switch. These requirements must be met:* MAC addresses must be learned dynamically* Log messages must be generated without disabling the interface when unwanted traffic is seen Which two commands must be configured to complete this task"? (Choose two)

SW(config.if)sswitchport port-security mac-address 0010.7B84.45E6

SW(ccnfig-if)=switchport port-security mac-address sticky

SW(confKj-if)=switchport port-security violation restrict

SW(config.if)sswitchport port-security mac-address 0010.7B84.45E6

SW(config-if)aswitchport port-security maximum 2

SW(ccnfig-if)=switchport port-security violation shutdown

Refer to the exhibit. Traffic from R1 to the 10.10.2.0/24 subnet uses 192.168.1.2 as its next hop. An network engineer wants to update the R1 configuration so that traffic with destination 10.10.2.1 passes through router R3, and all other traffic to the 10.10.20/24 subnet passes through r2. Which command must be used?

Ip route 10.10.2.1 255.255.255.255 192.168.1.4 100

Ip route 10.10.2.1 255.255.255.255 192.168.1.4 115

Ip route 10.10.2.0 255.255.255.0 192.168.1.4 100

Ip route 10.10.2.0 255.255.255.0 192.168.1.4 115

Ip route 10.10.2.1 255.255.255.255 192.168.1.4 100

What is a similarity OM3 and OM4 fiber optical cable?

Both have a 50 micron core diameter.

Both have a 62.5 micron core diameter.

Both have a 50 micron core diameter.

Both have a 100 micron core diameter.

Both have a 9 micron core diameter.

Why is TCP desired over UDP for application that require extensive error checking, such as HTTPS?

UDP operates without acknowledgments, and TCP sends an acknowledgment for every packet received.

UDP reliably guarantees delivery of all packets, and TCP drops packets under heavy load.

UDP uses flow control mechanisms for the delivery of packets, and TCP uses congestion control for efficient packet delivery.

UDP uses sequencing data tor packets to arrive in order, and TCP offers trie capability to receive packets in random order.

An engineer is configuring a switch port that is connected to a VoIP handset. Which command must the engineer configure to enable port security with a manually assigned MAC address of abod-bod on voice VLAN 4?

switchport port-security mac-address abcd.abcd.abcd

switchport port-security mac-address abed.abed.abed vlan 4

switchport port-security mac-address sticky abcd.abcd.abcd vlan 4

switchport port-security mac-address abcd.abcd.abcd vlan voice

What is the function of northbound API?

It provides a path between an SDN controller and network applications.

It upgrades software and restores files.

It relies on global provisioning and configuration.

It supports distributed processing for configuration.

It provides a path between an SDN controller and network applications.

Cisco 200-301 Practice Test 18 - Free Online Exam Prep & Questions

Refer to the exhibit.

Cisco 200-301 image Question 581 110089 10072024004421000000

An engineer must configure the interface that connects to PC 1 and secure it in a way that only PC1 is allowed to use the port No VLAN tagging can be used except for a voice VLAN. Which command sequence must be entered to configure the switch?

Become a Premium Member for full access

Unlock Premium Member

Cisco 200-301 Practice Test 18

Question

Cisco 200-301 Practice Tests

Practice Tests