What is the default behavior of a Layer 2 switch when a frame with an unknown destination MAC address is received?

The Layer 2 switch floods packets to all ports except the receiving port in the given VLAN.

The Layer 2 switch drops the received frame

The Layer 2 switch floods packets to all ports except the receiving port in the given VLAN.

The Layer 2 switch sends a copy of a packet to CPU for destination MAC address learning.

The Layer 2 switch forwards the packet and adds the destination MAC address to its MAC address table

Which command automatically generates an IPv6 address from a specified IPv6 prefix and MAC address of an interface?

ipv6 address 2001:DB8:5:112::/64 eui-64

ipv6 address 2001:DB8:5:112::2/64 link-local

An engineer is asked to protect unused ports that are configured in the default VLAN on a switch.Which two steps will fulfill the request? (Choose two)

Administratively shut down the ports

Configure the port type as access and place in VLAN 99

Configure the ports in an EtherChannel.

Administratively shut down the ports

Configure the port type as access and place in VLAN 99

Configure the ports as trunk ports

Enable the Cisco Discovery Protocol

Refer to the exhibit. An extended ACL has been configured and applied to router R2 The configuration failed to work as intended Which two changes stop outbound traffic on TCP ports 25 and 80 to 10.0.20 0 26 from the 10.0.10 0/26 subnet while still allowing all other traffic? (Choose two )

Add a "permit ip any any" statement at the end of ACL 101 for allowed traffic

The source and destination IPs must be swapped in ACL 101

Add a "permit ip any any" statement to the begining of ACL 101 for allowed traffic.

Add a "permit ip any any" statement at the end of ACL 101 for allowed traffic

The source and destination IPs must be swapped in ACL 101

The ACL must be configured the Gi0/2 interface inbound on R1

The ACL must be moved to the Gi0/1 interface outbound on R2

Which two capacities of Cisco DNA Center make it more extensible as compared to traditional campus device management? (Choose two)

SDKs that support interaction with third-party network equipment

REST APIs that allow for external applications to interact natively with Cisco DNA Center

adapters that support all families of Cisco IOS software

SDKs that support interaction with third-party network equipment

customized versions for small, medium, and large enterprises

REST APIs that allow for external applications to interact natively with Cisco DNA Center

modular design that is upgradable as needed

What is the primary effect of the spanning-tree portfast command?

It minimizes spanning-tree convergence time

It immediately puts the port into the forwarding state when the switch is reloaded

It immediately enables the port in the listening state

Refer to the Exhibit. After the switch configuration the ping test fails between PC A and PC B Based on the output for switch 1. which error must be corrected?

There is a native VLAN mismatch

Access mode is configured on the switch ports.

The PCs are m the incorrect VLAN

All VLANs are not enabled on the trunk

Which statement identifies the functionality of virtual machines?

The hypervisor can virtualize physical components including CPU. memory, and storage

Virtualized servers run most efficiently when they are physically connected to a switch that is separate from the hypervisor

The hypervisor can virtualize physical components including CPU. memory, and storage

Each hypervisor can support a single virtual machine and a single software switch

The hypervisor communicates on Layer 3 without the need for additional resources

Which option about JSON is true?

used to describe structured data that includes arrays

uses predefined tags or angle brackets () to delimit markup text

used to describe structured data that includes arrays

similar to HTML, it is more verbose than XML

How do TCP and UDP differ in the way they provide reliability for delivery of packets?

TCP provides flow control to avoid overwhelming a receiver by sending too many packets at once, UDP sends packets to the receiver in a continuous stream without checking for sequencing

TCP is a connectionless protocol that does not provide reliable delivery of data, UDP is a connection-oriented protocol that uses sequencing to provide reliable delivery.

TCP does not guarantee delivery or error checking to ensure that there is no corruption of data UDP provides message acknowledgement and retransmits data if lost.

TCP provides flow control to avoid overwhelming a receiver by sending too many packets at once, UDP sends packets to the receiver in a continuous stream without checking for sequencing

TCP uses windowing to deliver packets reliably; UDP provides reliable message transfer between hosts by establishing a three-way handshake

Which two command sequences must you configure on switch to establish a Layer 3 EtherChannel with an open-standard protocol? (Choose two )

interface GigabitEthernet0/0/1 channel-group 10 mode active

interface port-channel 10 no switchport ip address 172.16.0.1.255.255.255.0

interface GigabitEthernet0/0/1 channel-group 10 mode on

interface GigabitEthernet0/0/1 channel-group 10 mode active

interface GigabitEthernet0/0/1 channel-group 10 mode auto

interface port-channel 10 switchport switchport mode trunk

interface port-channel 10 no switchport ip address 172.16.0.1.255.255.255.0

What is an advantage of Cisco DNA Center versus traditional campus device management?

It supports numerous extensibility options including cross-domain adapters and third-party SDKs.

It supports high availability for management functions when operating in cluster mode.

It enables easy autodiscovery of network elements m a brownfield deployment.

It is designed primarily to provide network assurance.

By default, how Does EIGRP determine the metric of a route for the routing table?

it uses the bandwidth and delay values of the path to calculate the route metric

it uses a default metric of 10 for all routes that are learned by the router

it uses a reference Bandwidth and the actual bandwidth of the connected link to calculate the route metric

it counts the number of hops between the receiving and destination routers and uses that value as the metric

What is a difference between local AP mode and FiexConnet AP mode?

Local AP mode creates two CAPWAP tunnels per AP to the WLC

FiexConnect AP mode fails to function if the AP loses connectivity with the WLC

FlexConnect AP mode bridges the traffic from the AP to the WLC when local switching is configured

Local AP mode causes the AP to behave as if it were an autonomous AP

Which function does the range of private IPv4 addresses perform?

allows multiple companies to each use the same addresses without conflicts

provides a direct connection for hosts from outside of the enterprise network

ensures that NAT is not required to reach the internet with private range addressing

enables secure communications to the internet for all external hosts

What event has occurred if a router sends a notice level message to a syslog server?

An interface line has changed status

A TCP connection has been torn down

An ICMP connection has been built

An interface line has changed status

Refer to the exhibit. What two conclusions should be made about this configuration? (Choose two )

The spanning-tree mode is Rapid PVST+

The root port is FastEthernet 2/1

The designated port is FastEthernet 2/1

The spanning-tree mode is Rapid PVST+

The spanning-tree mode is PVST+

The root port is FastEthernet 2/1

What are two fundamentals of virtualization? (choose two)

It allows logical network devices to move traffic between virtual machines and the rest of the physical network

It allows multiple operating systems and applications to run independently on one physical server.

The environment must be configured with one hypervisor that serves solely as a network manager to monitor SNMP traffic

It allows logical network devices to move traffic between virtual machines and the rest of the physical network

It allows multiple operating systems and applications to run independently on one physical server.

It allows a physical router to directly connect NICs from each virtual machine into the network

It requires that some servers, virtual machines and network gear reside on the Internet

What is the difference regarding reliability and communication type between TCP and UDP?

TCP is reliable and is a connection-oriented protocol UDP is not reliable and is a connectionless protocol

TCP is not reliable and is a connection-oriented protocol; UDP is reliable and is a connectionless protocol

TCP is not reliable and is a connectionless protocol; UDP is reliable and is a connection-oriented protocol

TCP is reliable and is a connectionless protocol; UDP is not reliable and is a connection-oriented protocol

Refer to the exhibit. How does the router manage traffic to 192.168.12.16?

It selects the RIP route because it has the longest prefix inclusive of the destination address.

It chooses the OSPF route because it has the longest prefix inclusive of the destination address.

it load-balances traffic between all three routes

It chooses the EIGRP route because it has the lowest administrative distance

How does Cisco DNA Center gather data from the network?

Network devices use different services like SNMP, syslog, and streaming telemetry to send data to the controller

Devices establish an iPsec tunnel to exchange data with the controller

Devices use the call-home protocol to periodically send data to the controller.

The Cisco CU Analyzer tool gathers data from each licensed network device and streams it to the controller.

Cisco 200-301 Practice Test 4 - Free Online Exam Prep & Questions

Question 1 / 40

Which QoS Profile is selected in the GUI when configuring a voice over WLAN deployment?

Bronze

Platinum

Silver

Gold

Comment (0)

Cisco 200-301 Practice Test 4

Question

Cisco 200-301 Practice Tests

Practice Tests