Cisco 200-301 Practice Test - Questions Answers, Page 59

An engineer must configure R1 for a new user account. The account must meet these requirements:

* It must be configured in the local database.

* The username is engineer.

* It must use the strongest password configurable. Which command must the engineer configure on the router?

Refer to the exhibit.

Router R1 resides in OSPF Area 0. After updating the R1 configuration to influence the paths that it will use to direct traffic, an engineer verified that each of the four Gigabit interfaces has the same route to 10.10.0.0/16. Which interface will

R1 choose to send traffic to reach the route?

What is a requirement when configuring or removing LAG on a WLC?

Refer to the exhibit.

The DHCP server and clients are connected to the same switch. What is the next step to complete the DHCP configuration to allow clients on VLAN 1 to receive addresses from the DHCP server?

What provides centralized control of authentication and roaming In an enterprise network?

Refer to the exhibit.

Traffic sourced from the loopback0 Interface is trying to connect via ssh to the host at 10.0.1.15.

What Is the next hop to the destination address?

Refer to the exhibit.

Which configuration allows routers R14 and R86 to form an OSPFv2 adjacency while acting as a central point for exchanging OSPF information between routers?

Refer to the exhibit.

Which network prefix was learned via EIGRP?

Refer to the exhibit.

How should the configuration be updated to allow PC1 and PC2 access to the Internet?