Cisco 200-301 Practice Test - Questions Answers, Page 95
Question list
Related questions
Which two transport layer protocols carry syslog messages? (Choose two.)
UDP
RTP
IP
TCP
ARP
What does traffic shaping do?
It modifies the QoS attributes of a packet
It queues excess traffic
It organizes traffic into classes.
It sets QoS attributes within a packet.
Refer to the exhibit.
Which set of commands must be applied to the two switches to configure an LACP Layer 2 EtherChannel?
A)
B)
C)
D)
Option A
Option B
Option C
Option D
Which enhancements were implemented as part of WPA3?
802.1x authentication and AES-128 encryption
TKIP encryption improving WEP and per-packet keying
AES-64 m personal mode and AES-128 in enterprise mode
forward secrecy and SAE in personal mode for secure initial key exchange
How is noise defined in Wi-Fi?
ratio of signal-to-noise rating supplied by the wireless device
signals from other Wi-Fi networks that interfere with the local signal
measured difference between the desired Wi-Fi signal and an interfering Wi-Fi signal
any interference that is not Wi-Fi traffic that degrades the desired signal
What is the difference between an IPv6 link-local address and a unique local address?
The scope of an IPv6 link-local address is limited to a loopback address, and an IPv6 unique local address is limited to a directly attached interface.
The scope of an IPv6 link-local address can be used throughout a company site or network, but an IPv6 unique local address is limited to a loopback address.
The scope of an IPv6 link-local address is global, but the scope of an IPv6 unique local address is limited to a loopback address.
The scope of an IPv6 link-local address is limited to a directly attached interface, but an IPv6 unique local address is used throughout a company site or network.
What is a difference between an IPv6 multicast address and an IPv6 anycast address?
A packet sent to an IPv6 multicast address is delivered to one or more destinations at once, but a packet sent to an IPv6 anycast address is routed to the closest interface with that address.
An IPv6 multicast address uses the prefix 2002::/15 and forwards to one destination, and an IPv6 anycast address uses the prefix ff00::/8 and forwards to any destination in a group.
IPv6 multicast addresses are used to transition from IPv4 to IPv6, and IPv6 anycast addresses are used for address aggregation in an IPv6-only environment.
An IPv6 multicast address is assigned to numerous interfaces within a subnet, but an IPv6 anycast address is used for a predefined group of nodes in an all-IPv6 routers group.
Which interface is used for out-of-band management on a WLC?
dynamic
service port
virtual
management
How is a configuration change made to a wireless AP in lightweight mode?
SSH connection to the management IP of the AP
EolP connection via the parent WLC
CAPWAP/LWAPP connection via the parent WLC
HTTPS connection directly to the out-of-band address of the AP
Refer to the exhibit.
What is missing from this output for it to be executed?
double quotes C') around the 'Cisco Devices' string
curly brace ()) at the end
exclamation point (!) at the beginning of each line
square bracket ([) at the beginning
Question