Cisco 200-301 Practice Test - Questions Answers, Page 97

List of questions
Question 961

Why choose Cisco DNA Center for automated lifecycle management?
Question 962

Which protocol does Ansible use to push modules to nodes in a network?
Question 963

Refer to the exhibit.
Which types of JSON data is shown
Question 964

A router received three destination prefixes:10.0.0/18, and 10.0.0/24. When the show ip route command is executed, which output does it return?
A)
B)
C)
D)
Question 965

Which mechanism allows WPA3 to provide a higher degree of security than its predecessors?
Question 966

Exhibit.
The switches are connected via a Cat5 Ethernet cable that was successfully tested. The Interfaces are configured as access ports and are both in a 'down' status. What is the cause of this issue?
Question 967

Refer to the exhibit.
All routers in the network are configured correctly, and the expected routes are being exchanged among the routeis. Which set or routes are learned from neighbors and Installed on router 2?
A)
B)
D)
Question 968

Refer to the exhibit.
A packet sourced from 172.16.32 254 is destined for 172.16.32.8. What is the subnet mask of the preferred destination route?
Question 969

Which cable type must be used when connecting a router and switch together using these criteria?
* Pins 1 and 2 are receivers and pins 3 and 6 are transmitters
* Auto detection MDi-X is unavailable
Question 970

Refer to the exhibit.
An engineer configures interface fa0/1 on SW1 and SW2 to pass traffic from two different VLANs. For security reasons, company policy requires the native VLAN to be set to a nondefault value. Which configuration meets this requirement?
A)
B)
C)
D)
Question