Cisco 200-301 Practice Test - Questions Answers, Page 63
Question list
List of questions
Related questions
Refer to the exhibit.
The administrator must configure a floating sialic default route that points to 2001:db8:1234:2::1 and replaces the current default route only if it fails. Which command must the engineer configure on the CPE?
ipv6 route ::/0 2001:db8:1234:2::1 3
ipv6 route ::/128 2001 :db8:1234:2::1 3
ipv6 route ::/0 2001:db8:1234:2::1 1
ipv6 route ::/0 2001:db8:1234:2::1 2
What is the function of "off-the-shell" switches in a controller-based network?
providing a central view of the deployed network
forwarding packets
making routing decisions
setting packet-handling policies
Which command do you enter so that a switch configured with Rapid PVST + listens and learns for a specific time period?
switch(config)#spanning-tree vlan 1 max-age 6
switch(config)#spanning-tree vlan 1 hello-time 10
switch(config)#spanning-tree vlan 1 priority 4096
switch(config)#spanning-tree vlan 1 forward-time 20
Refer to the exhibit.
Load-balanced traffic is coming in from the WAN destined to a host at 172.16.1.190. Which next-hop is used by the router to forward the request?
192.168.7.4
192.168.7.7
192.168.7.35
192.168.7.40
An engineer is configuring data and voice services to pass through the same port. The designated switch interface fastethernet0/1 must transmit packets using the same priority for data when they are received from the access port of the IP phone. Which configuration must be used?
A)
B)
C)
D)
Option A
Option B
Option C
Option D
Refer to the exhibit.
R1 has taken the DROTHER role in the OSPF DR/BDR election process. Which configuration must an engineer implement so that R1 is elected as the DR?
Option A
Option B
Option C
Option D
What is a feature of WPA?
802.1x authentication
preshared key
TKIP/MIC encryption
small Wi-Fi application
Refer to the exhibit.
The network administrator must prevent the switch Cat9K-2 IP address from being visible in LLDP without disabling the protocol. Which action must be taken must be taken to complete the task?
Configure the no lldp tlv-select-management-address command globally on Cat9K-2
Configure the no lldp transmit command on interface G1/0/21 in Cat9K-1
Configure the no lldp receive command on interface G1/0/21 on Cat9K-1
Configure the no lldp mac-phy-cfg command globally on Cat9K-2
Which WAN topology has the highest degree of reliability?
full mesh
Point-to-point
hub-and-spoke
router-on-a-stick
What are the two steps an engineer must take to provide the highest encryption and authentication using domain credentials from LDAP?
Select PSK under Authentication Key Management
Select WPA+WPA2 on Layer 2 Security
Select Static-WEP + 802.1X on Layer 2 Security
Select WPA Policy with TKIP Encryption
Select 802.1X from under Authentication Key Management
Question