Cisco 200-301 Practice Test - Questions Answers, Page 67
List of questions
Question 661

Refer to the exhibit.
An OSPF neighbor relationship must be configured using these guidelines:
• R1 is only permitted to establish a neighbor with R2
• R1 will never participate in DR elections
• R1 will use a router-id of 101.1.1.
Which configuration must be used?
Question 662

Which two wireless security stewards use Counter Mode Cipher Block Chaining Message Authentication Code Protocol for encryption and data integrity'? (Choose two.)
Question 663

What is the default port-security behavior on a trunk link?
Question 664

When a switch receives a frame for an unknown destination MAC address, how is the frame handled?
Question 665

Refer to the exhibit.
An engineer is configuring a Layer 3 port-channel interface with LACP. The configuration on the first device is complete, and it is verified that both interfaces have registered the neighbor device in the CDP table. Which task on the neighbor device enables the new port channel to come up without negotiating the channel?
Question 666

Refer to the exhibit.
What is the subnet mask of the route to the 10.10.13.160 prefix?
Question 667

What is the purpose of the Cisco DNA Center controller?
Question 668

Which encryption method is used by WPA3?
Question 669

What differentiates device management enabled by Cisco DNA Center from traditional campus device management?
Question 670

Refer to the exhibit.
A network engineer must configure R1 so that it sends all packets destined to the 10.0.0.0/24 network to R3, and all packets destined to PCI to R2. Which configuration must the engineer implement?
Question