Cisco 200-301 Practice Test - Questions Answers, Page 73

List of questions
Question 721

Which interface enables communication between a program on the controller and a program on the networking devices?
Question 722

Refer to the exhibit.
The loopback1 interface of the Atlanta router must reach the lookback3 interface of the Washington router.
Question 723

Refer to the exhibit.
Which action by the router when a packet is sourced from 10.10.10.2 and destined 10.10.10.16?
Question 724

What does a switch do when it receives a frame whose destination MAC address is missing from the MAC address table?
Question 725

Which security method is used to prevent man-in-the-middle attack?
Question 726

Refer to the exhibit.
R1 has just received a packet from host A that is destined to host B. Which route in the routing table is used by R1 to reac B?
Question 727

Which IPsec transport mode encrypts the IP header and the payload?
Question 728

Refer to the exhibit.
PC1 regularly sends 1800 Mbps of traffic to the server. A network engineer needs to configure the EtherChannel to disable Port Channel 1 between SW1 and SW2 when the Ge0/0 and Ge0/1 ports on SW2 go down. Which configuration must the engineer apply to the switch?
Question 729

Refer to the exhibit.
Which command must be enable a floating default route on router A?
Question 730

Refer to the exhibit.
How must OSPF be configured on the GigabitEthernet0/0 interface of the neighbor device to achieve.
Question