Cisco 200-301 Practice Test - Questions Answers, Page 70
Question list
List of questions
Related questions
Which command configures the Cisco WLC to prevent a serial session with the WLC CLI from being automatical togged out?
config sessions maxsessions 0
config sessions timeout 0
config serial timeout 0
config serial timeout 9600
Refer to the exhibit.
How many JSON objects are presented?
1
2
3
4
Which enhancement is implemented in WPA3?
applies 802.1x authentication
usesTKIP
employs PKI to identify access points
protects against brute force attacks
What must be considered for a locally switched FlexConnect AP if the VLANs that are used by the AP and client access are different?
The APs must be connected to the switch with multiple links in LAG mode
The switch port mode must be set to trunk
The native VLAN must match the management VLAN of the AP
IEEE 802.10 trunking must be disabled on the switch port.
Refer to the exhibit.
The network engineer is configuring router R2 as a replacement router on the network After the initial configuration is applied it is determined that R2 failed to show R1 as a neighbor Which configuration must be applied to R2 to complete the OSPF configuration and enable it to establish the neighbor relationship with R1?
What is an advantage of using auto mode versus static mode for power allocation when an access point is connected to a PoE switch port?
All four pairs of the cable are used
It detects the device is a powered device
The default level is used for the access point
Power policing is enabled at the same time
Which type of port is used to connect lo the wired network when an autonomous AP maps two VLANs to its WLANs?
LAG
EtherChannel
trunk
access
What is a function of an endpoint?
It is used directly by an individual user to access network services
It passes unicast communication between hosts in a network
It transmits broadcast traffic between devices in the same VLAN
It provides security between trusted and untrusted sections of the network.
Refer to the exhibit.
Wireless LAN access must be set up to force all clients from the NA WLAN to authenticate against the local database. The WLAN is configured for local EAP authentication. The time that users access the network must not be limited.
Which action completes this configuration?
Uncheck the Guest User check box
Check the Guest User Role check box
Set the Lifetime (seconds) value to 0
Clear the Lifetime (seconds) value
Refer to the exhibit.
An engineer is configuring a new Cisco switch NewSW, to replace SW2 The details have been provided
• Switches SW1 and SW2 are third-party devices without support for trunk ports
• The existing connections must be maintained between PC1 PC2 and PC3
• Allow the switch to pass traffic from future VLAN 10. Which configuration must be applied?
Question