Cisco 200-301 Practice Test - Questions Answers, Page 78
List of questions
Question 771

Refer to the exhibit.
Which two values does router R1 use to determine the best path to reach destinations in network 1,0.0.0/8? (Choose two.)
Question 772

Refer to the exhibit.
Host A switch interface is configured in VLAN 2. Host D sends a unicast packet destined for the IP address of host A.
What does the switch do when it receives the frame from host D?
Question 773

Which properly is shared by 10GBase-SR and 10GBase-LR interfaces?
Question 774

Refer to the exhibit.
A network engineer started to configure two directly-connected routers as shown. Which command sequence must the engineer configure on R2 so that the two routers become OSPF neighbors?
Question 775

Refer to the exhibit.
A network engineer must provide configured IP addressing details to investigate a firewall rule Issue.
Which subnet and mask Identify what is configured on the en0 interface?
Question 776

Refer to the exhibit.
What does route 10.0.1.3/32 represent in the routing table?
Question 777

Refer to the exhibit.
A network administrator must permit traffic from the 10.10.0.0/24 subnet to the WAN on interlace Seria10. What is the effect of the configuration as the administrator applies the command?
Question 778

What is the role of community strings in SNMP operations?
Question 779

Which access point mode relies on a centralized controller for management, roaming, and SSID configuration?
Question 780

What are two characteristics of a small office / home office connection environment? (Choose two.)
Question