Cisco 200-301 Practice Test - Questions Answers, Page 80
Question list
List of questions
Related questions
What is the functionality of the Cisco DNA Center?
data center network pokey con
console server that permits secure access to all network devices
IP address cool distribution scheduler
software-defined controller for automaton of devices and services
Refer to the exhibit. Local access for R4 must be established and these requirements must be met:
• Only Telnet access is allowed.
• The enable password must be stored securely.
• The enable password must be applied in plain text.
• Full access to R4 must be permitted upon successful login.
Which configuration script meets the requirements?
Refer to Exhibit.
Refer to the exhibit. What is represented by “R1” and “SW1” within the JSON output? y
object
value
key
arra
Refer to Exhibit.
Refer to the exhibit. The router R1 is in the process of being configured. Routers R2 and R3 are configured correctly for the new environment. Which two commands must be configured on R1 for PC1 to communicate to all PCs on the 10.10.10.0/24 network? (Choose two.)
ip route 10.10.10.0 255.255.255.0 192.168.2.3
ip route 10.10.10.10 255.255.255.255 192.168.2.2
ip route 10.10.10.10 255.255.255.255 g0/1
ip route 10.10.10.8 255.255.255.248 g0/1
ip route 10.10.10.0 255.255.255.248 192.168.2.2
What are two protocols within the IPsec suite? (Choose two)
AH
3DES
ESP
TLS
AES
When an access point is seeking to join wireless LAN controller, which message is sent to the APManager interface?
Discovery response
DHCP request
DHCP discover
Discovery request
Which protocol is used in Software Defined Access (SDA) to provide a tunnel between two edge nodes in different fabrics?
Generic Router Encapsulation (GRE)
Virtual Local Area Network (VLAN)
Virtual Extensible LAN (VXLAN)
Point-to-Point Protocol
Which IP header field is changed by a Cisco device when QoS marking is enabled?
Header Checksum
Type of service
DSCP
ECN
Refer to the exhibit.
The network engineer is configuring a new WLAN and is told to use a setup password for authentication instead of the RADIUS servers. Which additional set of tasks must the engineer perform to complete the configuration?
Disable PMF Enable PSK Enable 802.1x
Select WPA Policy Enable CCKM Enable PSK
Select WPA Policy Select WPA2 Policy Enable FT PSK
Select WPA2 Policy Disable PMF Enable PSK
Refer to Exhibit.
Refer lo the exhibit. What is the next-hop P address for R2 so that PC2 reaches the application server via ElGRP?
192.168.30.1
10.10 105
10.10.10.6
192.168.201
Question