Cisco 200-301 Practice Test - Questions Answers, Page 81
List of questions
Question 801

Refer to Exhibit.
Refer lo the exhibit. What is the next-hop P address for R2 so that PC2 reaches the application server via ElGRP?
Question 802

Refer to Exhibit.
Refer to the exhibit. An engineer must translate the PC1 IP address to 10.199.77.100 and permit PC1 to ping the loopback 0 on router R2. What command set must be used?
Question 803

Refer to the exhibit.
User traffic originating within site 0 is failing to reach an application hosted on IP address 192.168.0.10. Which is located within site A What is determined by the routing table?
Question 804

A network engineer must configure an interface with IP address 10.10.10.145 and a subnet mask equivalent to 11111111.11111111.11111111.11111000. Which subnet mask must the engineer use?
Question 805

Refer to the exhibit An IPv6 address must be obtained automatically on the LAN interface on R1 Which command must be implemented to accomplish the task?
Question 806

Refer to the exhibit.
Which configuration establishes a Layer 2 LACP EtherChannel when applied to both switches?
Question 807

What must a network administrator consider when deciding whether to configure a new wireless network with APs in autonomous mode or APs running in cloud-based mode?
Question 808

Under which condition is TCP preferred over UDP?
Question 809

Which protocol must be implemented to support separate authorization and authentication solutions for wireless APs?
Question 810

Refer to the exhibit.
An engineer assigns IP addressing to the current VLAN with three PCs. The configuration must also account for the expansion of 30 additional VLANS using the same Class C subnet for subnetting and host count. Which command set fulfills the request while reserving address space for the expected growth?
Question