Cisco 200-301 Practice Test - Questions Answers, Page 87
Question list
List of questions
Related questions
A network engineer must migrate a router loopback interface to the IPv6 address space. If the current IPv4 address of the interface is 10.54.73.1/32, and the engineer configures IPv6 address 0.0.0.0.0:ffff:a36:4901, which prefix length must be used?
/64
/96
/124
/128
Which port type does a lightweight AP use to connect to the wired network when it is configured in local mode?
EtherChannel
LAG
trunk
access
What is the primary purpose of a console port on a Cisco WLC?
In-band management via an asynchronous transport
out-of-band management via an IP transport
in-band management via an IP transport
out-of-band management via an asynchronous transport
Which two transport layer protocols carry syslog messages? (Choose two.)
TCP
IP
RTP
UDP
ARP
What describes a northbound REST API for SON?
application-facing interface for SNMP GET requests
network-element-facing interface for GET POST PUT and DELETE methods
network-element-facing interface for the control and data planes
application-facing interface far GET, POST, PUT, and DELETE methods
Refer to the exhibit.
A network engineer must configure communication between PC A and the file server. Which commend must be configured on switch A to prevent interruption of other communications?
switch port trunk allowed vlan 12
switchport trunk allowed vlan none
switchport trunk allowed vlan add 13
switch port trunk allowed vlan remove 10-11
A switch is a forwarding a frame out of an interfaces except the interface that received the frame.
What is the technical term for this process?
ARP
CDP
flooding
multicast
Refer to Exhibit.
SW1 supports connectivity for a lobby conference room and must be secured. The engineer must limit the connectivity from PCI lo ma SW1 and SW2 network. The MAC addresses allowed must be Limited to two. Which configuration secures the conference room connectivity?
Refer to the exhibit.
A network administrator configures an interface on a new switch so that it connects to interface Gi1/0/1 on switch Cat9300-1. Which configuration must be applied to the new interface?
switchport mode trunk
switchport trunk native vlan 321
switchport trunk allowed vlan 100,200,300
switchport mode dynamic desirable
switchport trunk native vlan 321
switchport trunk allowed vian 100,200,300
switchport trunk encapsulation dot1q
switchport trunk native vlan 321
switchport trunk allowed vlan 100-300
switchport nonegotiate
switchport access vlan 321
switchport trunk allowed vlan except 2-1001
What are two differences between WPA2 and WPA3 wireless security? (Choose two.)
WPA3 um AES for stronger protection than WPA2 which uses SAE
WPA2 uses 1 M-bit key encryption and WPA3 requires 256-brt key encryption
WPA3 uses AES for stronger protection than WPA2 which uses TKIP WPA3 uses
SAE tor stronger protection than WPA2 which uses AES
WPA2 uses 12B-M key encryption and WPA3 supports 128 bit and 192 bit key encryption
Question